Operation - ProDevice OMS500 Instruction Manual

Instruction manual ProDevice OMS500

4. OPERATION

1. Place the shredder on a hard surface in the designated, sheltered installation area.
2. Secure the shredder against shifting by by tightening the wheel brake bolts.
3. Make sure the shredded scrap bin is in the compartment and that the compartment
door is closed.
4. Open both media input compartments.
5. Apply the oil for cutting knives.
6. Extend the power cord and plug it into a power outlet.
7. Insert the key into the key switch.
8. Turn on the shredder with the key switch.
9. Start the cleaning function by holding down the REVERSE button for 6 seconds.
10. After cleaning, the shredder is ready for use. Place the storage device in the media input
compartment and close it.
11. Start the shredder by pressing the START button.
12. The device starts the work in an automatic mode. To shred another media, put it in the
media input.
13. The shredder will stop its work after 5 minutes. To restart it, press the START button.
14. Stop the shredder by pressing the STOP button or by opening the input media drawer.
15. Place another media in the media input drawer and press the START button to restart
the device.
16. In the event of overloading the device, the work of the shredding knives will be stopped.
To restart the shredder, open the OVERLOAD circuit breaker compartment in the housing
on the left side of the device and lift it up. Then start the shredder operation by pressing
the START button.
17. In case of pressing the EMERGENCY STOP button, the work of shredding knives will be
stopped. To restart the shredder, raise the EMERGENCY STOP button to its original
position, then press the START button.
18. To properly shut down the device, after the shredding cycle is complete, press the STOP
button and use the key switch.
19. Disconnect the power cord from the power outlet and wind it up.
www.pro-device.com
9