Marquis Vector21 Owner's Manual page 26

for normal use and operation. To access any of the following features press
TEMP +/- and then Light: then scroll through the features by continuing
to press the LIGHT button. You exit the programming mode at any time
by continuing to press the LIGHT button until you arrive back at the
temperature display or by simply pausing for 30 seconds.
Filtration Cycles (Factory default is 1 hour, two times per day) Your
filtration cycle may vary dependent on model and configuration.
Your swim spa will begin the first of two filtration cycles 5 minutes after it
has been powered up. The second filtration cycle will start 12 hours later.
To change the time when the filtration cycles run, power down the spa for
1 minute and then turn the power back on at the point in time you want the
spa to filter. For example, if you want the spa to filter at 3 PM and 3 AM,
power the swim spa down at 2:55 PM or 2:55 AM. This will reset when the
swim spa will run the filter cycles. In the event that the power to the swim
spa is interrupted, you will need to repeat this procedure.
Programming how long the spa will filter
The electronic controls will allow you to change the length of time the
swim spa will filter the water. This can be useful if your usage patterns
vary from light to heavy and/or you need more or less filtration time to aid
in maintaining water clarity. To adjust the filtration times, press the listed
buttons in the following sequence. Button presses must occur within 30
seconds of each other.
To Program:
1. Press the TEMP +/- button followed by the light button to enter the
programming mode to filter settings (FLTR).
2. Press the TEMP +/- button to make a change to the desired length of
time. (each press changes the time in 1 hour increments).
3. Press the LIGHT button to set your selection and exit the filtration time
option. If you do not do this the choice will not be saved.
Mode (Ready mode is factory default - recommended)
This feature can be used for periods when you will be gone for an extended
amount of time and don't want the swim spa running on a continual basis.
Running the unit in "Ready" mode will ensure the spa is at full temperature
and ready for use at any time. Running the unit in "Rest" mode will only allow
the spa to heat during a scheduled filtration cycle. When in REST mode
spa may display "RUN PMPS FOR TEMP" the pump needs to be running to
display an accurate temperature, no corrective action is required. To access
and change the mode, press the listed buttons in the following sequence.
Button presses must occur within 30 seconds of each other. Ready and
Rest indicators are shown under the temperature in the display.
To Program:
1. Press the TEMP +/- button followed by the light button to enter the
programming mode.
2. Press the LIGHT button again to enter the "mode" option.
3. Press the TEMP +/- button to toggle between "Ready" and "Rest"
options.
4. Press the LIGHT button to set your selection and exit the filtration time
option. If you do not do this the choice will not be saved.
VECTOR21 SPA CONTROL OPERATION
26