Table of Contents
Advertisement
Playing CDs
$
a
°C You can create your program while checking the disc
labels
While the disc tray is open, follow Steps 1 to 5 with
pressing DISC SKIP to check the disc labels. If you close
the disc tray before Step 5, the total playing time appears
in the display after a while.
Note that, if the programmed track number isn't found
on the disc, that step is automatically erased.
je) The program remains even after the Program Play
ends
When you press B, you can play the same program
again.
je) The program remains until you erase it or turn off the
player
If you replace discs, the programmed disc and track
numbers remain. So, the player plays only the existing
disc and track numbers. However, the disc and track
numbers that aren't found in the player or on the disc are
deleted from the program, and the rest of the program is
played in the programmed order.
Note
The total playing time doesn't appear when:
— You have programmed a track whose number exceeds 20.
—The total playing time of the program exceeds 200 minutes.
Changing the track order -
You can change your program before you start playing.
To
You need to
Erase the last step in
Press CLEAR. Each time you press
the program H
the button, the last track or disc will
be cleared.
Add steps to the end of
Follow Steps 2 to 4 in "Creating
-
the program
Your @wn Program" on page 10
Change the whole
Hold down CLEAR until "ALL
rogram completely
CLr" appears in the display to erase
FF
the whole program, then create a
new program following Steps 2 to 4
in "Creating Your Own Program"
on page 10
11
Advertisement
Table of Contents
