Advertisement
Speakers you can use with this unit and cable connections
„ Speakers you can use with this unit
This unit supports speakers with 4 Ω to 16 Ω impedance. For speaker impedance, check the speaker instruction manual.
„ (Note) Speaker Impedance
If any of the speakers to be connected has an impedance of 4 Ω or more and less than 6 Ω, set "Speaker Impedance" to "4ohms" for "Speaker Setup" in the Initial
Setup section ( →p74). When setting "Speaker Impedance" from the Setup menu, press the
and set "Speaker" - "Configuration", then set "Speaker Impedance" ( →p58) to "4ohms".
„ Connect the Speaker Cables
1/2˝
(12 mm)
Make correct connection between the unit's jacks and speaker's jacks (+ side to + side, and - side to - side) for each channel. If the connection is wrong, a bass
sound will not be reproduced properly due to reverse phase. Twist the wires exposed from the tip of the speaker cable so that the wires do not stick out of the
speaker terminal when connecting. If the exposed wires touch the rear panel, or the + side and - side wires touch each other, a malfunction may occur.
Speaker Connections
HOME button on the remote controller to display the Setup menu,
3.1ch
5.1ch
3.1.2ch
20
Advertisement
