Advertisement
4. CONTENTS
1 Handle
2 Carry handle
3 Wing knob
4 Power regulator
5 Latch
6 Rear wheel
7 Front castor
8 Container
9 Cover gasket
10 Suction port
11 Power take off socket
12 On/off switch
13 Filter cleaning button
14 Air flow indicator
15 Hose storage rack
16 Accessory storage
17 Squeegee inserts
18 Brush inserts (pre-installed)
19 Floor nozzle
20 Suction hose
21 Crevice tool
22 Dust bag (x5)
23 Round dust brush
24 Power tool hose adaptor
25 Metal extension wand (x3)
26 Foam filter
27 Cartridge filter (pre-installed)
28 Disposable bag (x5)
29 Washer (x4)
30 Hub cap (x2)
31 Wheel retaining pin (x2)
32 Wheel axle
33 Screw (x2)
34 Manual
5. ASSEMBLY
5.1.
Remove all the contents from inside of the vacuum cleaner container.
5.2.
Attach the carry handle into the slots located on the top of the power head. Secure them with supplied screws (Fig. 1).
5.3.
Turn the container upside down and insert the front feet with casters into the slots and apply pressure until they click into place (Fig.2).
5.4.
Insert the wheel axle into the rear wheel housing on the base. Insert a washer onto the axle followed by the rear wheel and another
washer. Insert the wheel retaining pin into the hole on the end of the axle to lock into place. Push fit the hub cap onto the wheel.
Repeat the same steps on the other end of the axle (Fig. 3).
5.5.
To position the hose storage rack, insert one end into the channel on the side of the power head, making sure it is secured in place.
Apply inward pressure to the other side and insert it into the opposite channel (Fig. 4).
5.6.
Unfold the upper handle assembly into the upright position. The upper handle has two adjustable height positions. Secure in place by
tightening the knobs clockwise (Fig. 5).
5.7.
The vacuum cleaner comes ready for dry vacuum cleaning with the cartridge filter pre-installed. If the cartridge filter is not installed,
refer to section 6.6.
5.8.
To maintain M-class certification this vacuum cleaner must be used with a means of disposable collection. By removing the dust bag
and disposable bag when collecting debris the user runs the risk of voiding vacuum cleaner certification.
5.9.
To use a dust bag, fully fit the dust bag flange onto the inlet stub (Fig. 6).
© Jack Sealey Limited
Original Language Version
PC380M Issue:1 08/04/21
Advertisement
