Download Print this page
Sealey PC195SD.V2 Manual

Sealey PC195SD.V2 Manual

Wet & dry 20ltr 1200w stainless drum

Advertisement

Quick Links

thank you for purchasing a Sealey product. manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
Wear Eye
instructions
Protection
1. Safety
1.1.
electrical Safety
WarninG! It is the user's responsibility to check the following:
Check all electrical equipment and appliances to ensure that they are safe before using. Inspect power supply leads, plugs and
all electrical connections for wear and damage. Sealey recommend that an RCd (Residual Current device) is used with all electrical
products. You may obtain an RCd by contacting your local Sealey stockist.
If the product is used in the course of business duties, it must be maintained in a safe condition and routinely PAT (Portable
Appliance Test) tested.
electrical safety information, it is important that the following information is read and understood.
1.1.1.
ensure that the insulation on all cables and on the appliance is safe before connecting it to the power supply.
1.1.2.
Regularly inspect power supply cables and plugs for wear or damage and check all connections to ensure that they are secure.
imPOrtant: Ensure that the voltage rating on the appliance suits the power supply to be used and that the plug is fitted with the
correct fuse - see fuse rating in these instructions.
DO nOt pull or carry the appliance by the power cable.
8
DO nOt pull the plug from the socket by the cable. Remove the plug from the socket by maintaining a firm grip on the plug.
8
DO nOt use worn or damaged cables, plugs or connectors. ensure that any faulty item is repaired or replaced immediately by a
8
qualified electrician.
1.1.3.
This product is fitted with a BS1363/A 13 Amp 3 pin plug.
If the cable or plug is damaged during use, switch off the electricity supply and remove from use.
Replace a damaged plug with a BS1363/A 13 Amp 3 pin plug. If in doubt contact a qualified electrician.
Class II products are wired with live (brown) and neutral (blue) only are marked with the Class II symbol;
A) Connect the BROWN live wire to the live terminal 'L'.
B) Connect the BLUE neutral wire to the neutral terminal 'N'.
C) After wiring, check that there are no bare wires and ensure that all wires have been correctly
connected.
ensure that the cable outer sheath extends inside the cable restraint and that the restraint is tight.
DO nOt connect either wire to the earth terminal.
8
Sealey recommend that repairs are carried out by a qualified electrician.
1.2.
General Safety
disconnect the cleaner from the power supply before servicing, changing accessories, or performing any maintenance.
9
Use only genuine parts and accessories. Unauthorised parts and accessories may be dangerous and will invalidate your warranty.
9
Maintain the cleaner in good condition. Use an authorised agent for servicing. Keep machine clean, but DO nOt use solvents.
9
For dry vacuuming ensure the dry reusable filter (section 5), is in place before operating the cleaner.
9
For wet vacuuming ensure the wet filter (section 8), is in place before operating the cleaner.
9
WarninG! Using the cleaner without the appropriate filters may cause damage to the vacuum cleaner and will invalidate your warranty.
Wear protective clothing and gloves.
9
DO nOt place attachments close to your face (especially eyes, ears, etc). DO nOt point the hose end at other persons or animals.
8
DanGer! DO nOt vacuum hot or glowing ash, cigarette ends, flammable, explosive, corrosive or other dangerous substances.
DO nOt leave machine running unattended. Turn power supply oFF, and DO nOt leave the vicinity until motor has come to a
8
complete stop.
DO nOt operate the cleaner while under the influence of drugs, alcohol or impairing medication, or if you are tired.
8
DO nOt use the cleaner in the rain or in very damp conditions.
8
DO nOt use the cleaner for a task it is not designed to perform.
8
When not in use, store the cleaner in a safe, dry, childproof location.
9
nOte: This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities
or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and
understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children
without supervision.
2. intrODuctiOn
High powered, lightweight unit with blower facility. Constructed from stainless steel, the drum unit is mounted on four castor wheels. Tool
storage points on head and base. Supplied with 4mtr cable, 3-pin plug and accessory tool kit, including three rigid extension tubes, wet-use
foam filter, cloth filter and dust bag.
© Jack Sealey limited
Vacuum cleaner Wet & Dry 20ltr 1200W
StainleSS Drum
Pc195SD.V2
model no:
Original Language Version
Recommended fuse rating
13 Amp
PC195Sd.V2 Issue 2 (3) 01/11/18

Advertisement

loading

Summary of Contents for Sealey PC195SD.V2

  • Page 1 Pc195SD.V2 model no: thank you for purchasing a Sealey product. manufactured to a high standard, this product will, if used according to these instructions, and properly maintained, give you years of trouble free performance. IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED.
  • Page 2: Specification

    The hose can be extended by using the three extension tubes, push together to fit to hose (fig.1.10). 4.1.10. To extend the hose use the extension tubes, push the tubes together (fig.1.11). 4.1.11. To attach the brush, push onto the tube extension (fig.1.12). Original Language Version PC195Sd.V2 Issue 2 (3) 01/11/18 © Jack Sealey limited...
  • Page 3: Dry Vacuuming

    5.1.10. Switch on the machine (fig.2.11). 5.1.11. Start vacuuming (fig.2.12). WarninG! DO nOt suck dust and liquid at the same time. ‰ 6. emPtyinG the DuSt barrel fig.3 Original Language Version © Jack Sealey limited PC195Sd.V2 Issue 2 (3) 01/11/18...
  • Page 4: Wet Vacuuming

    Clean air inlet filter sponge with water or with water and a mild detergent, then wring dry, this can be used again (fig.5.5). After wet vacuuming, turn the machine off and remove the plug. empty the container, clean and dry the machine inside and outside before storage. Original Language Version © Jack Sealey limited PC195Sd.V2 Issue 2 (3) 01/11/18...
  • Page 5 DO nOt let the machine work for more than 2 hours at a time, doing so will reduce the life of the machine. 11.7. If any abnormal vibrations, noises or smells occur stop using the machine immediately. Original Language Version © Jack Sealey limited PC195Sd.V2 Issue 2 (3) 01/11/18...
  • Page 6: Environment Protection

    Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim. Sealey Group, Kempson Way, Suffolk business Park, bury St edmunds, Suffolk. iP32 7ar 01284 757500 01284 703534 sales@sealey.co.uk...