Related Manuals for Bondtech LGX PRO
Summary of Contents for Bondtech LGX PRO
- Page 1 HOW TO Do regular maintenance on the LGX® PRO and LGX® PRO 2.85 Difficulty Medium Steps Time Required 10 to 15 min PRODUCT PAGE PRODUCT PAGE LGX® PRO 1.75 LGX® PRO 2.85 Sections...
-
Page 2: Instructions Guide
Rotate the extruder 90 degrees counterclockwise remove the interface plug. and remove the middle section. Remove the drivegears, plastic washers and pins. Remove the extruder assembly from the motor. Remove the lever, double gear and spring from the back SLS piece. Page 2/8 www.bondtech.se... - Page 3 Wipe off excess grease and solvent from the Apply a generous amount of grease to the motor Next, place the needle bearings on the drivegear needle bearings. Be careful to not loose needles. gear. pins and apply grease. Page 3/8 www.bondtech.se...
- Page 4 Insert the spring from the front of the SLS part. Add the double gear behind the spring. Shown here is the placement in the back. Push the double gear pin into the double gear. Add the right drivegear pin. Add the lever to the drivegear pin. Page 4/8 www.bondtech.se...
- Page 5 Push the lever all the way to the left. Add the middle SLS part. see fit. Place the assembly on the motor. Make sure that the lever is all the way to the left, Add the front plate. then add the front lever part. Page 5/8 www.bondtech.se...
- Page 6 Add your interface plug. Add your shortest screw to the top left hole. Add the rest of the screws. Tighten them down carefully. Turn the double gear to spread the grease and You are done! check for binding. Page 6/8 www.bondtech.se...
-
Page 7: How To Get Help
We are available to help you with any questions or issues you may have. Simply go to our website where you can access our customer support and send us your questions or follow the provided link: https://www.bondtech.se/contact/#tab_technical-support-requests Page 7/8 www.bondtech.se...