Program Input Section - Vestax PMC-170A Owner's Manual

PROGRAM INPUT SECTION

7
○ INPUT SELECTOR
1
Used to select input (2 line or 1 phono) to be sent to
each PGM channel.
○ TRIM CONTROL
2
Adjusts the input level of each channel. Set INPUT
FADER to 7-8 position, adjust the TRIM CONTROL
so that the sufficient signal is fed without distortion.
○ BALANCE CONTROL
3
Adjusts the stereo balance for each PGM channel.
Can be used for adjusting the unbalanced stereo
image. Clockwise rotation from center position
increases the volume of R over L channel. A counter
clockwise rotation increases the volume of L
channel over R.
○ EQUALIZER (HI 10Hz +6dB∼-24dB, Shelving type)
4
Adjusts the HI frequeny level of each PGM channel.
○ EQUALIZER (MID 1KHz +6dB∼-24dB, Peaking type)
5
Adjusts the MID frequeny level of each PGM
channel.
○
EQUALIZER (LOW 80Hz +6dB∼-24dB, Shelving type)
6
Adjusts the LOW freguency level for each PGM
channel.
○ EQ CUT SWITCH ( HI, MID, LOW )
7
1
Cuts off the each frequency range by 24dB. The
EQUALIZER volume dose not function when this
2
switch is set to "CUT".
○ EFFECT SWITCH
3
8
Used to send the signal to the external effect processor
connected to the effect SEND/RETURN.
4
○ P.F.L.. SWITCH
9
Used to send the signal from the PGM channel to the
5
monitor section for headphone monitoring.
○ OVERLOAD INDICATOR
10
6
Lights when input level is over.
○ INPUT FADER
11
This is a detachable fader for the ease of
8
replacement. Replace with IF-17 when it is worn
out.
9
10
Remove four screws which is holding the fader
●
panel.
11
Remove the fader unit.
●
Carefully remove the multi-cable connector from
●
the fader unit.
Insert the connector to the new fader unit.
●
Place the fader unit and tighten the screws.
●
Remove four
sarews
5
HOW TO REPLACE THE FADER
+ +
角4点のネジを
外す。
+
+
Remove the multi
マルチケーブル
cable connector
コネクターを抜く