Advertisement
PROGRAM
INPUT SECTION
PGM 1
INPUT
PHONO 1
LINE 2
1
LINE 1
TRIM
2
MIN
MAX
BAL
3
L
R
EQ
HI
-16dB
+16dB
MID
4
-12dB
+12dB
LOW
-16dB
+16dB
EFFECT
5
PRE
OFF
POST
CUE
6
OFF
ON
SIGNAL
10
9
8
7
6
5
7
4
3
2
1
0
PROGRAM INPUT SECTION
1. INPUT SELECTOR
Used to select input (2line or 1phono) to be sent to each PGM channel.
2. TRIM CONTROL
Adjusts the Input level of each channel. Set INPUT FADER to 7- 8position. adjust
TRIM so that the INPUT LEVEL METER shows about 0dB.
3. BALANCE CONTROL
Adjusts the stereo balance for each PGM channel. Can be used for adjusting the
unbalanced stereo image caused by a strong anti-skating setting. Clockwise rotation
from center position Increases the volume of R over L channel. A counter clockwise
rotation Increases the volume of L channel over R.
4. EQUALIZER(HI,MID,LOW)
Adjusts the HI, MID, LOW frequencies for each PGM channel. Each band has
following specifications.
HI
8kHz
MID
500Hz
LOW
80Hz
5. EFFECT SWITCH
This switch enables the signal from each programs to be sent to AUX send jack.
Different signal routes can be selected this switch to different positions.
P R E :
The signal before the input fader ( after the EQ ) will be sent to AUX
output.
POST :
The signal after the input and cross fader will be sent to AUX output.
O F F :
No signal will be sent to AUX output.
6. CUE SWITCH
Used to send the signal from each
program to monitor section for
headphone monitoring.
7. INPUT FADER
Used to adjust the Input level of each
program. Usually set at the 7-8
position. This is a detachable fader for
the ease of replacement. Replace with
the IF-27 when It is worn out.
HOW TO REPLACE THE INPUT FADER
●
Remove four screws which hold the
fader unit panel.
Take the unit out with the panel
●
Carefully remove the multi-cable
connector from the fader unit.
●
Insert the connector to the new fader
unit.
●
Put the fader unit panel in position
and tighten the screws.
8. CROSS FADER
When the Input level of PGM1 and
PGM2 are properly set, PGM1 will be
heard with the cross fader set to the
left side. PGM2 will be heard with
the cross fader set to the right side.
When the cross fader is set in the
center, both programs will be heard.
This is detachable fader for the ease
of replacement witrh CF-R when it is
worn out.
±12dB Shelving type
±16dB Peaking type
±12dB Shelving type
Remove four screws.
Remove four screws.
Remove the multi-
cable connector from
fader unit.
Remove the multi-cable
connecter from fader unit.
Advertisement
