CONGRATULATIONS ! Thank you for purchasing the Vestax PMC-CX Professional Mixing Controller. We suggest that you read through this owner's manual thoroughly so that you may enjoy the full use of this product safety and in the knowledge of all its special features and suitably applications.
When the product exhibits a distinct change in perfromance-this indicates need for service. F E A T U R E S ・The PMC-CX was built to give Carl Cox what he 3 Band Isolators on each PGM always wanted. A solid, reliable, high quality mixer, that ・The PMC-CX features a superb 3-band isolator on...
See "HOW TO t PGM ISOLATOR HI CHANGE THE FADER UNIT". Adjusts the HI frequency level of each PGM. *Replace this fader with a Vestax IF-500 replacement y PGM ISOLATOR MID inputfader. Adjusts the MID frequency level of each PGM.
#7 PHONES JACK Use this jack to connect headphones. Headphones with an impedance of 8ohm to 600ohm can be used on this unit. *For best sound quality Vestax recommends using Headphones with 150ohm impedance. HOW TO CHANGE THE FADER UNIT REAR PANEL...
JACKS $7 on the rear panel. carefully. See "HOW TO CHANGE THE FADER UNIT". !6 MASTER CUE SWITCH *Replace this fader with a Vestax CF-50 replacement Used to send the signal from MASTER OUT1/2 to the inputfader. monitor section for headphone monitoring. When switch is on, an indicator lights up.
High Pass, Low Pass & Notch Filter (effect) on each PGM Suitable for all DJs ・On the PMC-CX each PGM has a filter effect section ・With more than enough creative room for even the with a high pass, low pass and (when pressed most experimental DJs the PMC-CX is truly suitable for together) a notch filter.
SPECIFICATION NOMINAL INPUT MAIN MIC(XLR FEMALE 2PIN HOT BALANCED) -50dBv SUB MIC (φ6.3 PHONE JACK UNBALANCED) -50dBv INPUT PHONO 1∼4 L R (RCA PIN JACK) -46dBv SECTION LINE 1∼4 SUB L /R (RCA PIN JACK) 0dBv MASTER LOOP RCV(φ6.3 PHONE JACK UNBALANCED) 0dBv ...