Table of Contents
Advertisement
o ©
10.
11.
12.
13.
14.
15.
ITEM
TOTAL DOTS
TOTAL LINES |
ee
H-CENTER
.V-CENTER
according to the present signal input.
The function of the parameters and their values are summarized
in the
table below.
. For your reference, "PC CONFIGURATION"
is also available. This will
Move the arrow to an item that you want to adjust by pressing the POINT
BUTTON (UP/DOWN).
To increase the level, point the arrow to A and then press the REAR
CLICK BUTTON. To decrease the level, point the arrow to V and then
press the REAR CLICK BUTTON.
If you want to store the settings to the memory,
move
the arrow to
MEMORY and press the REAR CLICK BUTTON. When you have stored
the settings, you will see "OK !" as a confirmation.
Press the REAR
CLICK BUTTON to quit.
Whenever you want to quit the MENU, point to QUIT and then press the
REAR CLICK BUTTON.
If you quit the MENU
without storing the settings to the memory,
the
parameter data will be kept as you stored them last time even if you have
changed some values.
The stored settings are permanently held even if the MAIN ON/OFF is
switched off.
PC CONFIGURATION
TOTAL LINES
630
H-FREQUENCY
37.8
QUIT
POLARITY
H+V+
t
FUNCTION
image.
screen, adjust this.
adjust this.
V-WINDOW
V-RAM SYNC
Expanding or compressing level for the vertical direction.
Expanding or compressing level for the horizontal direction
To be adjusted to lessen the skew noise.
. To be adjusted to eliminate the VRAM noise generated by the partial scan
MODE 1 STORED
TOTAL DOTS
TOTAL LINES
Al
MAC/XGA
9g 3/8
XP
We
A d
KIDI
H-CENTER
V-CENTER
:
KID
CLAMP
Q o o
KD
H-SHIFT
OFF
Ivi
HEIGHT
WIDTH
V-WINDOW
V-RAM SYNC
D
o
KIB
=
m
= o a x<
The number of the total dots in one horizonta! period. Adjust the number to match your PC
The number of the total vertical lines. Adjust the number to match your PC image.
Switch to match a MAC/XGA image signal. When MAC or XGA image is to be projected,
Adjustment of the horizontal picture position. When the image is not centered on the
Adjustment of the clamp level. When the image has a dark bar, try this adjustment.
Coarse adjustment of the CLAMP position. To be adjusted in conjunction with CLAMP.
Advertisement
Table of Contents
