Specifications; Intended Use - Makita LS0816F Instruction Manual

ENGLISH (Original instructions)

SPECIFICATIONS

Model:
Blade diameter
Hole diameter European countries
Countries other than Europe
Max. kerf thickness of the saw blade
Max. miter angle
Max. bevel angle
No load speed (RPM)
Dimensions (L x W x H)
Net weight
Safety class
• Due to our continuing program of research and development, the specifications herein are subject to change
without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2014
Cutting capacities (H x W) with ø 216 mm saw blade
Miter angle
0°
45° (left and right)
Symbols
The followings show the symbols which may be used
for the equipment. Be sure that you understand their
meaning before use.
Read instruction manual.
DOUBLE INSULATION
Wear safety glasses.
To avoid injury from flying debris, keep
holding the saw head down, after making
cuts, until the saw blade has come to a
complete stop.
When performing slide cut, first pull car-
riage fully and press down handle, then
push carriage toward the guide fence.
Do not place hand or fingers close to the
saw blade.
Adjust sliding fences clear of saw blade
and blade guard properly.
Do not stare at operating lamp.
45° (left)
36 mm x 305 mm
36 mm x 215 mm
13 ENGLISH
LS0816F
216 mm
30 mm
25.4 mm or 30 mm
(country specific)
2.8 mm
Left 47°, Right 47°
Left 47°, Right 2°
5,000 min
476 mm x 705 mm x 521 mm
13.9 kg
/II
Bevel angle
0°
65 mm x 305 mm
65 mm x 215 mm
Only for EU countries
Due to the presence of hazardous compo-
nents in the equipment, used electrical and
electronic equipment may have a negative
impact on the environment and human
health.
Do not dispose of electrical and electronic
appliances with household waste!
In accordance with the European Directive
on waste electrical and electronic equip-
ment and its adaptation to national law,
used electrical and electronic equipment
should be collected separately and
delivered to a separate collection point
for municipal waste, operating in accor-
dance with the environmental protection
regulations.
This is indicated by the symbol of the
crossed-out wheeled bin placed on the
equipment.

Intended use

The tool is intended for accurate straight and miter
cutting in wood. With appropriate saw blades, aluminum
can also be sawed. For details, according to the section
for OPERATION.
-1
2° (right)
60 mm x 305 mm
-