Napoleon Astound-Built In Series Installation And Operation Manual page 25

ECO
Boost
Thermostat
Control
Flame
Flame Speed
Ember Bed
Color
Hold the button for 3s to turn on/off heater with half heat output (ECO mode).
Note:
When running in ECO mode, ECO indicator will light up on the control panel.
Hold the button for 3s to turn on/off Boost mode for 30 mins.
Note: When runnning in Boost mode, BST indicator will light up
on the control panel.
Control the temperature of the appliance. Use
Settings:
18ºC [64ºF], 19ºC [66°F], 20°C [68ºF], 21ºC [70ºF], 22ºC [72ºF], 23ºC [74ºF],
24ºC [76ºF], 25ºC [78ºF], 26ºC [80ºF], 27ºC [82ºF] and OFF.
Note: Press and hold the button for 3s to switch between °C and °F.
Turn the flame effect on/off.
Press the button, flame 1 icon on the LCD display will start to flash.
Use the to change brightness.
Press the button again, flame 2 icon on the LCD display will start to flash.
Use the to change brightness.
Press the button for a third time, both flame 1 and flame 2 icons on the LCD
display will start to flash.
Icon 1: Orange flame. Icon 2: Yellow flame.
OF4 (100%) YF4 (100%)
OF3 (75%) YF3 (75%)
OF2 (50%) YF2 (50%)
OF1 (25%) YF1 (25%)
OF0 (0%) YF0 (0%)
Control the flame speed.
Press the button, flame speed icon will start to flash on LCD display.
Use to change settings.
Settings:
S-3 (12 RPM)
S-2 (10.5 RPM)
S-1 (9 RPM)
S-5 (15 RPM)
S-4 (13.5 RPM)
S-3 (12 RPM)
Control the ember bed color.
Press the button, ember bed color icon will start to flash on the LCD display.
Use to change settings.
Settings:
L01
L02
...
L13
L-C (Cycle)
L01
operation
to change settings.
Icon 1 + 2: Both flames.
F-1 Both flame on (100%)
F-0 Both flame off. (0%)
W415-4170 / C-0 / 10.25.23
EN
25