Table of Contents
Advertisement
Placement
Place the amplifier on a flat level surface like a table or shelf . It should be placed
upright so that its weight rests on the four attached feet . Placing the weight of the
amplifier on the rear or front panel for even an instant will result in damage to the
amplifier's connectors and controls .
Like any hi-fi component, the amplifier will last much longer if it is given adequate
ventilation for proper cooling . When installing in a cabinet, be sure that the rear
of the cabinet is open to fresh air to provide proper cooling (see Figure 1) . If the
cabinet's design will not accommodate an open rear, install two small "boxer fans"
to provide continuous air flow into and out of the cabinet (see Figure 2) . Place
the amplifier so that there is at least 7" of free air space above the chassis . If the
amplifier is located on a carpeted surface, place a board under the amplifier's feet .
Do not block the ventilation holes on the top and bottom of the amplifier .
CAUTION! When using low impedance speaker loads (less than 8 ohms Normal
Mode) refer to Figure 2 for proper placement .
Figure 1
Make sure that there is a minimum of 7" of free air
space above the amplifier for proper ventilation .
Allow a minimum of 2" of depth behind unit to
accommodate cables and connectors .
Installation Considerations
Boxer Fan (55 CFM)
directly centered 7"
on top of the Amplifier .
8
Figure 2
If the cabinet rear is not open to fresh air or if
you're using low impedance loads, install two
"boxer fans" to provide continuous air flow into
and out of the cabinet .
Boxer Fan (55 CFM)
directly centered 2"
behind the Amplifier .
Advertisement
Table of Contents
Troubleshooting
