Kenwood 1050CD Instruction Manual page 14

Programmed play (PGM mode)
The program mode allows you to play desired tracks in the order you want to hear them. A maximum of 32 selections
can be entered in memory.
@ Playing desired tracks in desired order
Preparation: Press the [@] key to set the unit in the stop mode.
1 Enter the PGM mode. 3 Start playback.
Each time the key is pressed, indicator lights up.
'the setting changes.
eZ 'T: PGM lights.
'2} Goes off.
P.MODE
rr
ia) {
=
Go to step 2 within 8 seconds.
elf the [mi] is pressed during programmed playback. the track being
QD) Select the disc. DISC SKIP
orec 1 orc 2 mac 3 CHSC 4
To check the programmed order
Remote control unit
Main unit (Except for 103CD}
indicator lights up
CHECK |
i
Go to step (2: within 8 seconds.
as aa
@ Select the track number. max so ,
4 ree ae iA
NMain'unit Remote control unit ui} '
{Except for 103CD}
D:splay showing program No. 72, DISC 3.
1 2
3
track No ?.
6 6 > <9
4 Ss
am om am
eS oO CS @ Every time the |CHECK|key is pressed, the track No. and the order it
was programmed (P-No.} are displayed in the order of programming.
eThe previous display will resume in a few seconds.
Examples of input
Track No. 11 :
Go to step @ within 8 seconds.
> Press the P MODE key.
P. MODE
To resume normal playback
@ The playback in the order of the track Nos. on CD will start after the
track being played.
Track number
@ By repeating steps ©, @, and ), up to 32 tracks may be selected.
If "FULL" is displayed, no further programming can be accepted.
elf you made a mistake, press the key and seiect the
correct track.
To stop programmed playback
To program all tracks on a disc:
D Select the desired disc.
= Press the key again.
Lights up.
14 = \050CD/104CD/103CD (En)