EXAI3248.Qx 12/12/2 8:12 PM Page 40
[ 40 ]
T H E I N T E G R A T E D A N S W E R I N G D E V I C E
Setting the ring time
The ring time setting allows you to set the number of rings the caller hears before
your answering system plays the outgoing message. You can set the ring time to
answer after two, four, or six rings. Setting
picks up after two rings if you have new messages, and after four rings if there are
none. This way, if you make a long distance call to check your messages, you can
hang up after the second ring to avoid billing charges.
1) Press clock/menu three times in standby mode.
You hear "Ring time" and the current ring time ([
Toll saver), and it is displayed on the base. Then you hear the guidance for setting.
2) Press select/volume
3) Press set to select the new ring time. You hear a confirmation tone, then the
announcement "Ring time" and the new ring time is announced. After a few
seconds, the system announces "To set record time, press menu again".
(Toll Saver), the answering system
or
key until the desired ring time appears.
] 2, [
] 4, [
] 6, [
www.uniden.com
]