Canon NP-1010 Service Manual page 66

V. DEVELOPING SYSTEM
A. Developing Assembly
1. Construction
3) Turn the screw counterclockwise.
4) Pull out the drum unit slowly.
g
0
2.
1)
2)
Developing cylinder
Stirring blade
Toner cartridge
Figure 4-35
Removing the Developing Assembly
Open the top unit.
Push the developing assembly release lever
deep inside the copier, and push it up in
the direction of the arrow.
@ Developing assembly release lever
@ Screw
@I Drum unit
Figure 4-36
. Do not expose the drum unit to sun-
light.
.
Do not leave finger prints or scratches
on the drum.
Return the developing assemblv release
lever to the position shown in Figure 4-37.
Remove the screw, and remove the devel-
oping assembly pressure unit.
0
Screw
@ Spring
@ Developing assembly pressure unit
Figure 4-37
7) Disconnect the relay connector
0 Relay connector
Figure 4-38
COPVAI6HT 01998 CAAOH INC.
CANON NP-1010 RE9.0 DEC. 1988 PAINTEA IN JAPAN IIMPAIME AU JAPONI 4-13,