Canon NP-1010 Service Manual page 60

2.
I)
2)
3)
4)
Removing the Pick-Up Roller and Cas-
sette Holder
Remove the lower front cover, lower rear
cover, and lower right cover.
Open the top unit, remove the two screws,
and remove the power supply/AC driver
cover; see Figure 4-57.
Remove the two fastons from the pick-up
clutch solenoid (PUSL).
Remove the screw with a washer.
Registration Roller
Removing the Registration Roller
Remove the manual feed lower guide and
pick-up lower guide; see Figures 4-15 and
-16.
Remove the two mounting, screws, and re-
move the registration solenoid cover and
registration roller.
@ Fastons @ Screw (w/ washer)
5)
6)
Figure 4-17
Close the top unit, and stand the copier on
its right side.
Remove the six screws, and remove the
pick-up roller and cassette holder.
@
Screws
@ Registration solenoid cover
@ Registration roller
Figure 4-l 9
0
Screws
@ Cassette holder
Figure 4-18
@ Registration roller
Figure 4-20
COPVAIGHT @II908 CANON INC. CANON HP-1010 AN.0 DEC. 1988 PAINTEO IN JIPQN (IMPRIMf AU JAPONI
4-7