Samsung NSG6 83 Series User Manual page 49

Problem Cause
There is steam This is normal.
or smoke coming
from under the
control panel.
A burning or oily This is normal for a new
odor coming from oven and will disappear
the vent. within 1 / hour of the first
2
bake cycle.
Strong odor. This is temporary.
The oven racks are This is normal.
difficult to slide.
Fan noise. This is normal.
The convection fan This is normal.
is not working.
Action
The oven vent is located there.
More steam is visible when
you are using the convection
functions or when baking or
roasting multiple items at the
same time.
To speed the process, set
a self-cleaning cycle for a
minimum of 3 hours.
(See page 42.)
The insulation around the
inside of the oven emits an
odor the first few times the
oven is used.
Apply a small amount of
vegetable oil to a paper towel,
and then wipe the edges of
the oven racks with the paper
towel. Racks become dull and
hard to slide if they are left in
the oven during a self-clean
cycle.
The convection fan runs until
the function is over or the
door is opened.
The fan starts automatically
when the oven reaches the
preheat temperature.
Others
Problem Cause
The product is not The appliance has been
level. installed improperly.
The leveling leg(s) is (are)
damaged or uneven.
The kitchen cabinets are
not properly aligned and
make the range appear to
be not level.
The display goes The electrical outlet
blank. Ground Fault Interrupter
(GFI or GFCI) has been
tripped and needs to be
reset.
Your digital control has
been damaged.
Action
Make sure the floor is level,
strong, and stable. If the floor
sags or slopes, contact a
carpenter.
Check and level the range.
(See the Installation
Instructions.)
Ensure that cabinets are
square and provide sufficient
room for installation.
Replace the fuse or reset the
circuit breaker.
English 49