Rating Plate; Installation - Tricity Bendix SI 255 Operating And Installation Instructions

WARNING: THIS APPLIANCE MUST BE EARTHED
RATING PLATE
Record the model and serial numbers on the back
cover of this instruction book, from the rating plate.
This is situated on the lower front frame of the
appliance and can be seen upon opening the oven
door.
TRICITY BENDIX MADE IN BRITAIN TRICITY BENDIX
MODEL NO KK KOK KK UL INLET AUD A Tn
propuct no rara NENA
SERIAL No œ w xc oe ok ok nc nc y x INI]
VOLTAGE XK Kk V # K KHz BEAB
WATTAGE X * KW € C Approved
The appliance must be protected by a suitably rated
fuse or circuit breaker. The rating of the appliance is
given on the rating plate.
INSTALLATION
This appliance complies with Radio Interference
requirements of EEC Directive 87/308/EEC.
If your cooker has been damaged in transit, contact
your supplier immediately. DO NOT attempt to install
it.
Your cooker left the factory fully packaged to protect
it from damage. If it is delivered without packaging
and damage has occurred, the manufacturer cannot
accept responsibility. Contact your supplier for
advice.
Once the packaging has been removed the cooker
should only be moved by hand. DO NOT use a sack
barrow or any other aid to lift the cooker as damage
may occur.
Connection to the electricity supply must be carried
out by a qualified electrician/competent person.
The electrical connection should be made using a
double pole isolating switch (cooker socket) with at
least 3mm contact separation. The cable must have
conductors of sufficiently high cross-sectional area to
prevent overheating and deterioration.
Six square millimetres (6.00mm) is the recommended
cross-section area.
The cable should be routed away from potentially hot
areas marked by X in the diagram below.
x
To move the cooker, open the oven door and lift the
cooker by holding inside the top of the compartment.
This is a type Y appliance which means it is
free-standing and can be fitted with cabinets on one
or both sides. It may also be fitted in a corner setting.
Side walls which are above hob level should be
protected by heat resistant non-combustible material
and MUST NOT be nearer than 40mm to the hob
side.
A nominal air gap of 2mm all around the cooker is
required to enable the cooker to be moved into
position.
A spacer has been incorporated into the back of the
appliance to ensure an air gap of 10mm is
maintained at hotplate level. Tiles or other forms of
deep wall covering should not obscure this gap.
Incorrect
Air gap
obscured_ Tiles
by wall
5 or 10mm covering
ay gap