Error
When?
message
After turning
on, you
heard a
strange
Generic alarm
noise after
the infuser
started
moving
During
operation
Grind too fine,
adjust
mill/grinder
Possible
causes
Upper and
Check microswitch and in case replace
lower
microswitch
are not closed
Presence of
1 - Reset coarseness of the grinder turning the knob
air in water
toward a higher number ( ONLY WHILE GRINDER
circuit
MOTOR IS RUNNING).
2 - Push in the water tank to make sure it is well in
place, then insert water spout (or turn steam knob) to
clear the circuit from air lock.
3 - Check connection and if necessary, replace the
flowmeter.
4 - Check the permanent filter, underneath the water
tank, for any obstructions of water flow: clean or
replace.
5 - Check for the fault on the blocked boiler,
disconnect the inlet water tube from the boiler and
run the pump clearing the air lock. (in test mode).
39
Solutions