Table of Contents
Advertisement
WARNING!
The Resume function should only be used if
traffic and road conditions permit. Resuming a
set speed that is too high or too low for prevail-
ing traffic and road conditions could cause the
vehicle to accelerate or decelerate too sharply
for safe operation. Failure to follow these warn-
ings can result in a collision and death or seri-
ous personal injury.
•
To Vary The Speed Setting
○ Once the vehicle speed has been set, you
can increase the speed by pushing the SET
switch upward or decrease the speed by
pushing the SET switch downward.
•
Setting The Following Distance In ACC
○ To decrease the distance setting, push the
Distance Setting Button and release. Each
time the button is pushed, the distance set-
ting increases by one bar (longer). Once the
longest setting is reached, if the button is
pushed again it will be set to the shortest
setting available.
Use this QR code to access your
digital experience.
GARAGE DOOR OPENER
(HOMELINK®)
The HomeLink® buttons are located in the over-
head console or sun visor and contain three
optional HomeLink® channels.
•
TO ERASE ALL SET CHANNELS: Push and hold
the two outside HomeLink® buttons for 20 sec-
onds until the indicator flashes above the
buttons.
•
ROLLING OR NON-ROLLING? Check your
garage door opener motor in your garage for a
"LEARN" or "TRAIN" button by the hanging
antenna. If you have one of these, you have a
Rolling Code garage door opener.
1. While the car is ON, hold the handheld garage
door transmitter 1-3 inches from the
HomeLink® button you want to program in the
Scan me
vehicle.
2. Push and hold both the HomeLink® button
being programmed and the button on the
garage door transmitter.
3. For Non-Rolling Code garage door openers,
watch for the indicator light to stay
illuminated.
For Rolling Code garage door openers, watch
for the indicator light to go from a slow blink
to blinking rapidly.
4. For Rolling Code garage door openers only,
firmly push and release the "LEARN" or
"TRAIN" button on your garage door opener
motor in your garage, then push the
HomeLink® button in your vehicle three times
(holding the button for two seconds each
time).
WARNING!
•
Your motorized door or gate will open and
close while you are programming the univer-
sal transmitter. Do not program the transmit-
ter if people or pets are in the path of the
door or gate.
•
Do not run your vehicle in a closed garage or
confined area while programming the trans-
mitter. Exhaust gas from your vehicle contains
carbon monoxide (CO) which is odorless and
colorless. Carbon monoxide is poisonous
when inhaled and can cause you and others to
be severely injured or killed.
INTERIOR
31
Advertisement
Table of Contents
