How To Set The Oven Control; Setting The Clock, To Set Time Of Day - Zanussi ZCM 32 T Instruction Manual

ZCM 32T
How to Set
the Oven Control
Please Note:
|. Each time a pad is touched, a beep will sound to
verify the touch.
2. The time of day automatically returns to the display
window when the oven turns off.
3. If the clear pad is touched, this crases all the
information given to the oven except the clock and
memory.
Make sure the oven is properly installed and plugged
in.
NOW PLACE A CUP OF WATER IN THE OVEN
AND CLOSE THE DOOR. FOLLOW THE OPER-
ATING INSTRUCTIONS BELOW.
DO NOT ALLOW THE CUP OF WATER TO BOIL
DRY. - REFILL, IF NECESSARY.
Setting the Clock
When the oven is plugged in, "1:01" will appear in the
display window. This clock is a twenty-four hour clock,
so from 23:59 it will go to 0:00.
13
To set Time of Day
Example: 13:45 24 hr Clock
* Touch the D pad.
* Touch the @ pad -
within 5 seconds.
"> 0" will appear in the
display window.
s emp
i |
¢ Touch the numeral pads. «
(For setting the time of
day, the MIN pads set
the hours and the SEC
pads set the minutes.)
pad once "10:00" will appear
pad three times
pad four times
"13:00" will appear
"13:40" will appear
"13:45" will appear
~ afta sft- afte
= pad five times
"13:45" will appear in the display window.
* Touch the ©: pad again.
The two dots between the hour and the minutes will
flash every other second.
To reset the time of day, repeat the steps given above.
To check time of day while oven is operating, touch the
<o} pad and the time will be displayed for
5 seconds.