Pioneer SX-2700 Operating Instructions Manual page 12

PRESET TUNING
FREQUENCY PRESETTING
Allows three stations per STATION CALL switch (press once, twice,
or three times to select)
LISTENING TO BROADCASTS USING PRESET
TUNING
1
1. Press the POWER switch to the ON position.
NOTE: '
Be sure to turn the TAPE 2 MONITOR switch OFF when listening to
AM or FM broadcasts.
2. Set the BAND selector to either FM or AM.
3. Tune in the desired station.
* See the section DIRECT ACCESS TUNING" for infermation on
reception using the Direct Access Tuning mode.
© See the section "AUTO TUNING" for information on reception
using the Auto Tuning mode
* See the section "MANUAL TUNING" for information on reception
using the Manual Tuning mode.
In addition to station frequencies, the FM MODE (AUTO/MONO)
can also be preset.
4. Press the MEMORY switch.
5. Press the STATION CALL switch into which you wish
to preset the station,
* Press the STATION CALL switch while the MEMORY indicator
is flashing {about 5 seconds).
* Use the STATION CALL switches (*1 — *9, *O) to select a preset
channel. One press selects the 1 — 10 range, two presses 11 —
20, and three presses 21 — 30.
[Example] If you press key [3] :
Once ~ STATION 3
Twice — STATION 13
Three times — STATION 23
Press a STATION CALL switch within two seconds.
When the display stops flashing, the station is preset.
NOTE:
Bo not press switches, during display is flashing.
6. Repeat steps 2 to 5 to preset additional stations.
Total of 30 AM and FM stations may be preset. When you store
a new preset, it takes the place of the previously stored station
(if any}.
12
<ARBI213>
1. Press the POWER switch to the ON position.
2. Press the STATION CALL switch into which the
desired station has been preset.
* When the Function switch is set to a function other than TUNER,
it will switch to the TUNER function automatically if one of the
STATION CALL switches is pressed.
Tuning can be performed simply and accurately following the
above procedure.
3. Adjust the volume and tone as desired.
NOTE:
The contents of the STATION CALL switch will be preserved for several
days, even if the receiver power cord is unplugged.
if @ preset station has been erased, preset it again.
Last station memory
The last received AM and FM stations remain stored despite FUNCTION
and/or POWER switching. To recall, use BAND selector switches,
HOW TO USE THE CUSTOM MEMORY
Preset stations can be classified into as many as three different genres
according to the material played by the station. Each of these three
genres can be given a name, and Memory Scan of all the stations of
8 particular genre can be carried out.
The initial STATION CALL numbers are classified and named as follows.
STATION CALL NO. NAME
1 10 PoP
11 — 20 ROCK
21 — 30 OTHER
It is recommended that you assign station call switches to appropriate
stations to be preset.