Pioneer SX-2700 Operating Instructions Manual page 11

DIRECT ACCESS TUNING
LISTENING TO BROADCASTS USING DIRECT
ACCESS TUNING
When you know the frequency of the desired station, the frequency
can be input directly using the STATION CALL (number) switches in
the following way:
1. Press the POWER switch to the ON position.
NOTE.
Be sure to turn the TAPE 2 MONITOR switch OFF when listening to
AM or FM broadcasts.
2. Select either FM or AM using the BAND selector
switch.
3. Press the DIRECT ACCESS tuning switch.
* In the Direct Access tuning mode, the DIRECT ACCESS tuning
indicator will fight up.
4. Input the desired station frequency using the
STATION CALL switches.
Example 1: To receive FM 106.00 MHz
DIRECT ACCESS tuning indicator lights up
Press the DIRECT
-
| raf MHz |
bate ei)
|
oo hs — | ee a
H em iL} MHz
Press +O
re
em | LI CL santa |
|
Press +6
|
mc [|
em
fF LE LE LE LD ee
tl)
Press +0
Once the station frequency has been input, the receiver tunes in that
frequency. If the input frequency falls below the tower or higher':
of the receiver's receivable frequency range (FM: 87.5 MHz» 148
MHz: AM: 530 kHz ~ 1,700 kHz (10 kHz step), 531 kHz» 1,652
kHz (9 kHz step} "LOWER" or UPPER" is displayed, indicating at
the frequency which has been input cannot be tuned in,
5. Adjust the sound volume and tone as desired.
To cancel frequency input
Direct access is canceled when the DIRECT ACCESS tuning switcr is
pressed again.
Under the following conditions direct access is canceled and the rit
returns to the condition in effect before direct access was selectec *
if there is no key input for about five seconds after the DIRECT ACCE%5
tuning switch was pressed, (2) it more than about eight seconds ela:.se
between number input.
Notes regarding direct access tuning (100 kHz step only)
* There is no need to input the last digit ''0'' of the desired stan
frequency
VW
<ARBI2>