Table of Contents
Advertisement
4.3 Installation
4.3.1
Installation of the standard machine
OBLIGATION:
All the phases of installation must be covered in the general project.
Before starting the installation activities, in addition to defining the technical requirements, the person authorised to perform the
work must, if necessary, implement a "safety plan" to safeguard the safety of the people directly involved, and strictly implement
the safety rules and, in particular, the laws that apply to mobile construction sites.
Before installing the machine, be sure that:
•
the area is perfectly flat and can ensure long-term stability;
•
the floor of the building on which the machine is to be installed is of adequate capacity;
•
the machine is easily accessible to all people who must interact with it during its expected useful life.
•
it must be possible to perform all maintenance and replacement operations (routine and extraordinary) easily and without
risks to people and in compliance with the laws in force concerning safety at work.
•
the spaces are adequate to ensure appropriate air flow for correct machine operation and ventilation.
•
the minimum space requirements for operation and inspection indicated in this manual are ensured.
•
air intake and delivery are never hindered or obstructed, even partially.
•
if people and vehicles are expected to transit in the vicinity, suitable fencing must be erected, in compliance with existing
regulations and ensuring at least the minimum required clearance around the machine for carrying out any intervention
that may be required on the same.
The machine must be installed indoors, in a non-aggressive atmosphere.
OBLIGATION:
The unit must be installed in an area where access is only permitted to OPERATORS,
MAINTENANCE PERSONNEL and TECHNICIANS. If this is not possible, it must be enclosed in a
perimeter fence positioned at least two metres from the external surfaces of the machine itself.
The staff of the INSTALLER or any other visitors must always be accompanied by an OPERATOR.
Under no circumstances, must unauthorised personnel be left alone in contact with the machine.
The MAINTENANCE MAN must limit him/herself to the controls of the machine only; the only panel
that can be opened by him/her is the one that accesses the control module - no other must be touched.
The INSTALLER may only connect the machine to the system.
Access the machine using the relative personal protective equipment and only after having read and
understood the documents and instructions, which must always be kept close at hand.
4.3.2
Machine positioning
The machine is placed directly on the ground. Once the machine has been positioned, it must be checked that it is level in the
four positions indicated in the figure.
Spirit level
Installation, use and maintenance manual
18
Advertisement
Table of Contents
