Table of Contents
Advertisement
MOTOR BELT TENSION
TO CHECK:
1.
IMPROPER BELT TENSION MAY CAUSE NOISE, OVERLOAD OF MOTOR, SLOW
RUNNING OR MOTOR BELT JUMPING.
2.
THE BELT DEFLECTION SHOULD BE 7 MM – 9 MM WHEN PRESSING THE MIDDLE
OF THE MOTOR BELT WITH APPROXIMATELY 300 GRAMS OF PRESSURE.
ADJUSTMENT PROCEDURE:
1.
REMOVE THE BELT COVER (SEE PAGE 1).
2.
LOOSEN THE SCREWS (A) AND (B).
3.
MOVE THE MOTOR UP OR DOWN TO ADJUST THE DEFLECTION ABOUT 7 MM -9
MM.
4.
TIGHTEN THE SCREWS (A) AND (B).
5.
ATTACH THE BELT COVER.
MECHANICAL ADJUSTMENT
(A)
300g LOAD
DEFLECTION 7-9MM
(B)
19
Advertisement
Table of Contents
