Advertisement
Quick Links
Specifications
• Handmade in Italy since 1960
• ¼ Turn valves handmade at
Nicolazzi Factory
• Lead Free Brass Compliant to
AZ/NZS 3718
• Suitable even and uneven
pressure
• Handles are interchangeable
Further information Phone (03) 9761 4603
Classic Prov Pillar Taps Cross Handle
Art: Z2517
Available replacement
handles:
WM22315
AS/NZS3662
Canterbury Sink & Tap Co.
Max/Min Operating
Pressure: 100/500kPa
sales@sinkandtap.com.au
Advertisement
Related Manuals for NICOLAZZI Z2517
Summary of Contents for NICOLAZZI Z2517
- Page 1 Classic Prov Pillar Taps Cross Handle Art: Z2517 Specifications Available replacement handles: • Handmade in Italy since 1960 • ¼ Turn valves handmade at Nicolazzi Factory • Lead Free Brass Compliant to AZ/NZS 3718 • Suitable even and uneven pressure...
- Page 2 420 kPa or less pressure than 270 kPa may affect the diverting action in side spray tap ware. Do not use any Nicolazzi tap ware with sulphurous water. The minimum temperature for all tap ware is 10 degrees Celsius . Below 10 degrees Celsius will void the warranty.
- Page 3 Installation Instructions Model : Z2517 ❶ Preparation Tap body Flush out the pipework to remove any foreign matter. Tap body cut out hole sizes : Maximum 32mm diameter. Under side clearance : Maximum 35mm Installation Guide ❷...
- Page 4 Installation Instructions Model : Z2517 ❶ Under the basin counter, stack the supplied rubber washer 3, above the stainless steel plate 4, and feed them onto the tap body thread section. Then fit the brass mounting nut 5, onto the tap thread section. Screw the brass mounting nut until rubber washer mates up with the underside of the sink.
- Page 5 Installation Instructions Model : Z2517 ❹ Connect main Hot and Cold water supplies to the side body thread sections, using the correct flexi tail hoses. From the back view, the Cold water supply is connected on the left hand side, with the Hot water supply on the right hand side.
- Page 6 Spare Parts list Model : Z2517 Further information Phone (03) 9761 4603 sales@sinkandtap.com.au...
- Page 7 Care and Maintenance Instructions Model : Z2517 Removing and replacing a handle MODEL SHOWN :Z2517 ❶ ❷ Unscrew and remove the indice button Using a Philips head screw driver, unscrew A, from the tap handle body. the handle retaining screw.
- Page 8 Care and Maintenance Instructions Model : Z2517 MAINTENANCE FOR THREE HOLE/TWO LEVER TAPWARE INSTRUCTIONS FOR REPLACEMENT OF THE HOT OR COLD CARTRIDGE Do not replace the cartridge if there is low flow or no flow. Low flow or no flow is caused by obstruction or kinking of supply hoses.
- Page 9 Care and Maintenance Instructions Model : Z2517 LOW FLOW OR NO FLOW TROUBLESHOOTING INSTRUCTIONS Current bathroom taps have a max flow rate of 7 Litres per minute from the aerator and the hand spray. If you are experiencing low flow from the spout: Do not change the cartridge •...
- Page 10 Care of external finishes Nicolazzi products are all authentic finishes that have not been coated with any product. After each use, pat the fixture down to remove any excess water. This will prevent any water spotting or mineral build-up. Use only soft liquid soap and water to clean the surface.