Advertisement
Quick Links
Specifications
• Handmade in Italy since 1960
• ¼ Turn valves handmade at
Nicolazzi Factory
• Lead Free Brass Compliant to
AZ/NZS 3718
• Suitable even and uneven
pressure
• Handles are interchangeable
Further information Phone (03) 9761 4603
SINK MIXER WALL MOUNTED
Art: Z1455
PESCARA
WM22315
AS/NZS3662
Canterbury Sink & Tap Co.
Max/Min Operating
Pressure: 100/500kPa
sales@sinkandtap.com.au
Available replacement
handles:
-
El Capitan Handle
-
78 Mont Blanc Handle
- 18 Dame Anglaise
-
70 Half Dome
Advertisement
Related Manuals for NICOLAZZI Pescara Z1455
Summary of Contents for NICOLAZZI Pescara Z1455
- Page 1 78 Mont Blanc Handle - 18 Dame Anglaise 70 Half Dome • Handmade in Italy since 1960 • ¼ Turn valves handmade at Nicolazzi Factory • Lead Free Brass Compliant to AZ/NZS 3718 • Suitable even and uneven WM22315 pressure AS/NZS3662 •...
- Page 2 420 kPa or less pressure than 270 kPa may affect the diverting action in side spray tap ware. Do not use any Nicolazzi tap ware with sulphurous water. The minimum temperature for all tap ware is 10 degrees Celcius . Below 10 degrees Celcius will void the warranty.
- Page 3 Installation Instructions Model : Z1455 Preparation Flush out the pipework to remove any foreign matter. The hot supply should be on the left when viewed from the front of the fitting. Water supply should Installed a minimum of 200 mm above fixture rim.
-
Page 4: Before Use
Installation Instructions Model : Z1455 ❹ Introduce the spout (E) in the central hat of the body (D) and screw the nut (F). ❺ Before use Turn on the Hot and Cold supplies to the tap. Maximum temperature for Hot water supply to the tapware is 62 °C. ... - Page 5 Spare Parts list Model : Z1455 Further information Phone (03) 9761 4603 sales@sinkandtap.com.au...
- Page 6 Care and Maintenance Instructions Model : Z1455 MAINTENANCE FOR WALL MOUNTED TWO LEVER TAP WARE INSTRUCTIONS FOR REPLACEMENT OF THE HOT OR COLD CARTRIDGE Do not replace the cartridge if there is low flow or no flow. Low flow or no flow is caused by obstruction or kinking of supply hoses.
- Page 7 Care and Maintenance Instructions Model : Z1455 Removing and replacing a handle MODEL SHOWN :Z 1457 ❶ ❷ Loosen and unscrew the retaining flange Once totally loose, simply remove the A, from the tap body. handle from cartridge spline. ❸...
- Page 8 Care and Maintenance Instructions Model : Z1455 LOW FLOW OR NO FLOW TROUBLESHOOTING INSTRUCTIONS Current kitchen taps have a max flow rate of 7 Litres per minute from the aerator. If you are experiencing low flow from the spout: Do not change the cartridge •...
- Page 9 Care of external finishes Nicolazzi products are all authentic finishes that have not been coated with any product. After each use, pat the fixture down to remove any excess water. This will prevent any water spotting or mineral build-up. Use only soft liquid soap and water to clean the surface.