Page 1
TAP MIXER FOR EXTERNAL COLUMN SHOWER Art: Z2525 Specifications Available replacement handles: • Handmade in Italy since 1960 • ¼ Turn valves handmade at Nicolazzi Factory • Lead Free Brass Compliant to WM22315 AZ/NZS 3718 AS/NZS3662 • Suitable even and uneven Canterbury Sink &...
Page 2
420 kPa or less pressure than 270 kPa may affect the diverting action in side spray tap ware. Do not use any Nicolazzi tap ware with sulphurous water. The minimum temperature for all tap ware is 10 degrees Celcius . Below 10 degrees Celcius will void the warranty.
Page 3
Installation Instructions Model : Z2525 Preparation Flush out the pipework to remove any foreign matter. The hot supply should be on the left when viewed from the front of the fitting. Assembly ❶ Connect the ¾” male to ½” female bush adaptors (A), to the1/2”...
Installation Instructions Model : Z2525 ❸ Fix the body of the wall mixer (D), placing the fibre washer (C), between the nut and the ¾” male to ½ “ female bush adaptors. Ensure all connections are firmly tightened.
Page 5
Spare Parts list Model : Z2525 Further information Phone (03) 9761 4603 sales@sinkandtap.com.au...
Page 6
Care and Maintenance Instructions Model : Z2525 Removing and replacing a handle MODEL SHOWN :Z2525 ❶ ❷ Unscrew and remove the indice button Using a Philips head screw driver, unscrew A, from the tap handle body. the handle retaining screw.
Page 7
Care and Maintenance Instructions Model : Z2525 MAINTENANCE FOR WALL MOUNTED TWO LEVER TAP WARE INSTRUCTIONS FOR REPLACEMENT OF THE HOT OR COLD CARTRIDGE Do not replace the cartridge if there is low flow or no flow. Low flow or no flow is caused by obstruction or kinking of supply hoses.
Page 8
Care and Maintenance Instructions Model : Z2525 LOW FLOW OR NO FLOW TROUBLESHOOTING INSTRUCTIONS Current bathroom taps have a max flow rate of 7 Litres per minute from the aerator. If you are experiencing low flow from the spout: Do not change the cartridge •...
Page 9
Care of external finishes Nicolazzi products are all authentic finishes that have not been coated with any product. After each use, pat the fixture down to remove any excess water. This will prevent any water spotting or mineral build-up. Use only soft liquid soap and water to clean the surface.