Advertisement
Quick Links
Specifications
• Handmade in Italy since 1960
• ¼ Turn valves handmade at
Nicolazzi Factory
• Lead Free Brass Compliant to
AZ/NZS 3718
• Suitable even and uneven
pressure
• Handles are interchangeable
Further information Phone (03) 9761 4603
SINK MIXER WALL MOUNTED
Art: Z2505
Available replacement
handles:
WM22315
AS/NZS3662
Canterbury Sink & Tap Co.
Max/Min Operating
Pressure: 100/500kPa
sales@sinkandtap.com.au
Advertisement
Related Manuals for NICOLAZZI Canterbury Z2505
Summary of Contents for NICOLAZZI Canterbury Z2505
- Page 1 SINK MIXER WALL MOUNTED Art: Z2505 Specifications Available replacement handles: • Handmade in Italy since 1960 • ¼ Turn valves handmade at Nicolazzi Factory • Lead Free Brass Compliant to AZ/NZS 3718 • Suitable even and uneven pressure WM22315 AS/NZS3662 •...
- Page 2 420 kPa or less pressure than 270 kPa may affect the diverting action in side spray tap ware. Do not use any Nicolazzi tap ware with sulphurous water. The minimum temperature for all tap ware is 10 degrees Celcius . Below 10 degrees Celcius will void the warranty.
- Page 3 Installation Instructions Model : Z2505 Preparation Flush out the pipework to remove any foreign matter. The hot supply should be on the left when viewed from the front of the fitting. Water supply should Installed a minimum of 200 mm above fixture rim.
-
Page 4: Before Use
Installation Instructions Model : Z2505 Before use ❹ Turn on the Hot and Cold supplies to the tap. Maximum temperature for Hot water supply to the tapware is 62 °C. Minimum recommended pressure is 100 kPa — Maximum recommended pressure is 500 kPa. ... - Page 5 Spare Parts list Model : Z2505 Further information Phone (03) 9761 4603 sales@sinkandtap.com.au...
- Page 6 Care and Maintenance Instructions Model : Z2505 Removing and replacing a handle MODEL SHOWN :Z2505 ❶ ❷ Unscrew and remove the indice button Using a Philips head screw driver, unscrew A, from the tap handle body. the handle retaining screw. ...
- Page 7 Care and Maintenance Instructions Model : Z2505 MAINTENANCE FOR WALL MOUNTED TWO LEVER TAP WARE INSTRUCTIONS FOR REPLACEMENT OF THE HOT OR COLD CARTRIDGE Do not replace the cartridge if there is low flow or no flow. Low flow or no flow is caused by obstruction or kinking of supply hoses.
- Page 8 Care and Maintenance Instructions Model : Z2505 LOW FLOW OR NO FLOW TROUBLESHOOTING INSTRUCTIONS Current kitchen taps have a max flow rate of 7 Litres per minute from the aerator. If you are experiencing low flow from the spout: Do not change the cartridge •...
- Page 9 Care of external finishes Nicolazzi products are all authentic finishes that have not been coated with any product. After each use, pat the fixture down to remove any excess water. This will prevent any water spotting or mineral build-up. Use only soft liquid soap and water to clean the surface.