Kenwood TM-255A Instruction Manual page 19

o)
|
tf
sii i i ® aoa
:)
se
7
@—- *M. CH oi
MENU FLOCK MHz A VFO B =—+ TONE REV — Aip| NB AUTO
(Ie cy Eel ym.
m
AE OO Chek Li. §
i i .ss
ra T£1.EI. usa ly ©
Cie. £
«—+ | BUSY
Cw +8
Stitt MTT futon BES Gross £0. 5
ON AIR}pe 2a fg | 8 ty
4
4
(9 STAR
Appears when the selected Page code is locked-out.
@ Meter
In Receive, acts as a Peak Hold S-meter to indicate
the signal strength of received signals from S1 to 40
dB over S9. In Transmit, acts as a Peak Hold RF
meter to indicate approximate transmit output power
on ascale from 1 to 10. The peak hold characteristic
can be disabled by menu selection if desired. The S-
meter is used for setting the squelch threshold of the
S-meter Squelch function.
@ LOW
Appears when Low transmit output power is selected.
When "LOW' is not visible, High output power is
selected.
@ DTSS
Appears when the Dual Tone Squelch System is ON
(FM mode only).
@ CTCSS
Appears when the Continuous Tone Coded Squelch
System is ON (FM mode only) when the CTCSS unit
is installed.
@ CO
Appears when Carrier-operated Scan Resume is ON.
When not visible, Time-operated Scan Resume is in
effect.
@ Cw
Appears when the CW mode is selected by pressing
[SSB/CW].
@ M.SCR
Appears when Memory Scroll is selected by pressing
[M.IN].
12
M. SCR /PRG SCAN \ # TOT—7—@
/
dé dyno 6
@ PRG
Appears when memory channel 99 is selected or
during Program Scan.
@ SCAN
Appears during Program Scan or Memory Scan.
@ TOT
Appears when the Time-out Timer function is ON.
@ Digital frequency display
Displays the transmit and receive frequencies. Also
displays menus while accessing Menu Setup or
DTSS/Page Code Select, and minutes/seconds for
Tone Alert.