Pioneer DC-Z74 Operating Instructions Manual page 23

MET PEAY EACK
|
* A compact disc, cassette or a radio broadcast can be used, as
well as an alarm sound.
* The current sound source can be played back beginning with
the time set by the TIMER function
* Timer playback begins everyday at the same time as long as
the timer playback mode is not turned off
* To receive the desired station for TIMER PLAYBACK, set the
frequency of the station to a channel and tune to that channel
before setting the timer, Otherwise, "LAST" will be displayed
and the station you previously listened to will be played back
at the time set for TIMER PLAYBACK
Tape playback:
* To use a tape for TIMER PLAYBACK, insert the tape into Deck.
CD playback:
« When you use a CD for TIMER PLAYBACK, the disc will be
played back from the beginning
[Timer Setting Example]
See Fig :1
Set WAKE-UP1 for receiving FM 103.00 MHz (STATION 9) from
7:15 to 8:00
(Follow the same steps when using WAKE-UP2.}
1. Tune to FM 103.00 MHz (STATION 9) using the STATION
CALL function.
2, Press the SET button, then the WAKE-UP7 button within 7
seconds.
3. Set the hour and minutes value of your desired wake-up time
by using the "~" (DOWN) and "+" (UP) buttons.
4, Press the SET button.
After the SET button is pressed, a time of one hour after the
wake-up time will be displayed. If you want to set this time for
turning the sound source OFF, press the SET button.
if you want to set a different time, proceed as follows:
5. Set the hour and minutes value of the turn-off time by using
the "-- (DOWN) and "+" (UP) buttons.
6. Press the SET button.
ON time, OFF time and function are displayed.
[To Activate the Timer]
7. Turn the power off if it is set to ON.
[To Change The Timer Setting]
Input the new setting, beginning with the first step.
{lf You Make a Mistake While Setting the Timer]
Complete the entire process first, and then input correctly from
the beginning.
[Turning the Timer ON/OFF]
After inputting the timer setting, check the tuner display to
confirm which timer is set to ON. The timer whose indicator is lit
{WAKE-UP [1] or [2)}) will be activated
Note that when the WAKE-UP button (/1] or [2]) is pressed and
the indicator is off, the timer will not operate. The timer can be
reactivated by pressing the WAKE-UP button, as the setting is
stored in the memory.
<SNOOZE function>
After TIMER PLAYBACK starts, you can turn the power
temporarily off by pressing the SNOOZE button of the remote
control unit. The power will be turned to ON again after
approximately & minutes.
NOTE:
Hf the remaining time for TIMER PLAYBACK is less than §
minutes, the power wilf continue to be off and playback will not
resume after 5 minutes even if the SNOOZE button is pressed.
NOTE:
When CD or TAPE has been set to TIMER, although none is
actually set, or when TUNER has been set and the TUNED
indicator is not lit, the unit will automatically search for a sound
souce and play it back.
a3
<ARB1278 >