Table of Contents
Advertisement
Preparation
You can easily separate the tripod from the PORT
underneath the tripod head. It enables you to use an optional SXG half pillar and other accessories sold separately.
1. An optional SXG half pillar can be used with the PORAT
2. With the installation of the SXG half pillar, an optional SX-HAL130 tripod can be used for the PORTA
3. An optional SX tabletop tripod can be used with the PORTA
*For usage of the SXG half pillar, refer to instruction manuals supplied with the SXG half pillar.
Example: Attaching to the SXG half pillar
*Refer to the set up chart below as for the installation of other optional
tripods available for the PORTA
Loosen the lock knob underneath the tripod head of the PORTA
and take the mount body off.
*Make sure to hold the mount body in one hand securely to avoid
falling off while you loosen the lock knob in the other hand.
Attach the SXG half pillar onto the tripod head so that the center
projection on the bottom of the SXG half pillar fits the sunken tripod
head. Tighten the lock knob underneath the tripod head securely.
Attach the mount head
II
of the PORTA
onto the
SXG half pillar and tighten
the lock knob as shown
in the figure.
Se tup G ui d e
Tabletop Tripod
Using an Optional SXG Half Pillar
II
Altazimuth mount assembly with the provided lock knob
II
.
❷
Tripod
II
PORTA
Mount Body
II
PORTA
Adapter
9
II
.
II
.
❶
II
❸
SXG Harf Pillar
Lock Knob
S X G H ar f P i l l a r
*The metal peg is not used
AL130-SP
Tripod for SKYPOD
*Standard supplied for PORTA II
II
.
Lock Knob
II
PORTA
Mount Body
Lock Knob
SXG-HAL130 Tripod
*The SXG half pillar is
needed
Advertisement
Table of Contents
