Table of Contents
Advertisement
2. ADJUSTMENT OF BT TORQUE IN PLAY MODE
(ADJUSTMENT OF THE TENSION ARM POSITON)
1. Remove the FL Ass'y.
2. Rotate the loading pulley with your finger until PLAY mode is reached.
3. Insert a standard screwdriver into the BT adjustment groove (a or b) of the main chassis.
Twist the screwdriver left and right to adjust gap(A) and gap(B) so that they are the same.
Loading Block Rail Groove
Tension Arm
BT Band Ass'y
Reel Ass'y
H.
©
=
BT adj. =
a
=
|-
0)
2
=
а
«
-
<
°
o
2
ч
I
О
Lu
°
То reduce the gap (BT torque reduction), insert into
e
To increase the gap (BT torque increase), insert into
=
adjustment groove "a" and twist counter-clockwise as
adjustment groove "b" and twist clockwise as shown
shown in the figure below.
in the figure below.
CAUTION:
Do not twist at too much of an angle. Doing so will have adverse effects on other areas as well.
MA-3
Advertisement
Table of Contents
