Mechanical Adjustments - Bang & Olufsen Beogram CD 5500 Service Manual

Bang & Olufsen
MEKANISKE JUSTERINGER
Hojde pa lobeverket
Justeringen foretages med de 4 skruer i gummidem-
perne i hjarnerne pa lobevzerket De 2 bageste skruer
kan justeres gennem hullerne F i pladeskuffen nar
skuffen er inde, og de 2 forreste nar skuffen er nzs-
ten ude. Der ber justeres lige meget og i samme retn-
ing pa alle 4 skruer. For at nd de 2 forreste skruer
skal den lange vinkel over fronten tages af, og for at
Jette justeringen vippes fronten ned.
Leg CD-plade i og tryk pladeskuffen ind.
Juster de 4 neevnte skruer til CD-pladens underkant er
0,3 mm -.0,3 mm over pladeskuffens overkant nar
pladeskuffen er inde.
5-1
MECHANICAL ADJUSTMENTS
Height of drive mechanism
Make the adjustment with the 4 screws in the rubber
dampers at the corners of the drive mechanism. The.
2 rearmost screws may be adjusted through the holes
F in the disc drawer when the drawer is in, and the 2
frontmost screws may be adjusted when the drawer is
almost out. All 4 screws should be adjusted identi-
cally. In order to reach the 2 frontmost screws, the
long bracket at the top of the front should be
removed, and the front should be tilted down to faci-
litate the adjustment.
Insert a CD and push in the disc drawer.
Adjust the 4 screws mentioned until the lower edge of
the CD is 0.3 mm +0.3 mm above the upper edge of
the dise drawer when the disc drawer is in.
Centrering af lobevzerk Centring of drive mechanism
A 8B
C
os Fe
O- =O
E D
/
. 4 =
aS [=
Leg en CD-plade i og tryk pladeskuffen ind.
Skruen A lesnes.
Ekscentrik B justeres til CD pladen er midt i fordyb-
ningen i pladeskuffen.
en A spandes.
Load a CD and push the disc drawer in.
Loosen screw A.
Using eccentric B, adjust until the CD is at the centre
of the depression in the disc drawer.
Tighten screw A.