Advertisement
Quick Links
Advertisement
Related Manuals for jbc GAL0405
Summary of Contents for jbc GAL0405
- Page 1 INSTRUCTION MANUAL GAL0405, GAL0608, GAL0910, GAL1115, GAL1618 Guide Kits for AL250...
-
Page 2: Packing List
This manual corresponds to the following references: Ref. 0002399 - Ø 0.4 - 0.5 mm / 0.015 - 0.02 in Ref. 0002402 - Ø 0.6 - 0.8 mm / 0.023 - 0.03 in Ref. 0002401 - Ø 0.9 - 1.0 mm / 0.035 - 0.04 in Ref. - Page 3 w w w.jbctools.com Guide Set Assembly 1. Unlock the dragging mechanism. 2. Place the guide set and tighten the screws. Guide Set 3. Insert the guide set in the tool. You 4. Tighten the guide tube screw to block the must leave a gap of 8-10 mm between the position of the guide.
- Page 4 5. Draw the solder wire from the reel to the 6. Close the dragging mechanism. entrance of the guide tube. Guide tube entrance...
- Page 5 w w w.jbctools.com 7. Connect the Auto-feed Iron to the station the solder wire comes out of the end of the and switch it on. Lift the auto-feed iron from guide tube. the stand and press the WIRE LOAD key until Fast wire LOADING dragging...
- Page 6 Driver Gear Replacement When using solder wire within Ø 1.1 and Ø 1.8 mm you must use the driver gear (ref. 0002863) for the dragging system to function properly. This gear replaces the one supplied with the station. To do this, follow these instructions: 1.
- Page 7 w w w.jbctools.com 2. Unscrew the clutch regulation assembly 3. Pull out the standard driver gear supplied and pull it out. with the station. 4. Place the new driver gear (ref. 0002863) 5. Place the regulation assembly and screw it. supplied with the guide set.
-
Page 8: Specifications
In order for the warranty to be valid, equipment must be returned, postage paid, to the dealer where it was purchased. Get 1 extra year JBC warranty by registering here: https://www.jbctools.com/productregistration/ within 30 days of purchase. This product should not be thrown in the garbage.