Table of Contents
Advertisement
Troubleshooting
The power does not go on.
The light source does not
light up.
No picture appears on the
screen.
Negative and positive of the
picture are reversed.
Left and right of the picture
are reversed.
Top and bottom of the
picture are reversed.
Color and the brightness is
inadequate.
The picture is not clear.
The color or brightness
changes when zooming or
trimming.
¢ The AC power cord is not plugged in to the wall outlet.
¢ The power switch has not been turned on.
¢ The fluorescent tube protection circuit is functioning.
¢ Turn off the power, then turn on again after about 5 seconds.
¢ The connection is incorrect.
¢ The power of other equipment has not been turned on.
© The IRIS control is in manual mode, and excessively out of
adjustment.
The setting of the NEGA/POSI switch is incorrect.
The film has been laid the opposite side down.
¢ The film has been laid up side down.
¢ The angle rorating dial is set to an incorrect position.
The IRIS control is in manual mode, and the CLOSE/OPEN control
is set to the incorrect position.
The COLOR BALANCE control is set to the incorrect position.
The color adjustment of the TV is incorrect.
The COLOR control is set to the incorrect position.
Adjust with the (manual) FOCUS button.
The film or lens is stained.
The original film was not focused when it was taken.
Adjust the iris manually, or hold the white balance level.
¢ The film on the film carrier is not placed properly, and the light
has hit the light source directly.
© The original film was extremely over or under exposed.
© The original film has too much contrast.
Advertisement
Table of Contents
