GE JGBP30 Owner's Manual & Installation Instructions page 46

Before you call for service...
Troubleshooting .tips
Possible Causes
i i
Excessive smoking
Excessive soil.
What To Do
• On models _th touch pads, touch the CLEAR/OFF pad.
On models with an OVEN TEMP knob, mrn it to OFE
Open the windows to ridthe room of smoke. _'ait until
the SELF CLEANlight goes otE Wipe up the excess soil
and reset the clean cycle.
Oven door willnotopen Oven too hot. • _Mlow the oven to cool below locking temperature.
after a clean cycle
Oven not clean after Oven controls not properly set. • See the Using the self-cleaning oven section.
a clean cycle
Oven was heavily soiled.
• Cle:m Ul_ heavv, sl_illove_
before starting, the clean cycle.
Heavily soiled ovens may need to sell:clean again or for
a longer period of time.
Oven door will not Oven is too hot. • _Mlow the oven to cool below locking temperature.
unlock (on models Do not lock the door with the door latch except when
with a doorlatch)
usin,, the self=clean teatul'e.
Self clean light (on The OVEN TEMP knob has not • Set the OVEN TEMP knob to CLEAN. See the Using the
some models) blinks been set to CLEAN when the self-cleaning oven section.
when trying to set a
latch was moved to the right.
self clean cycle
The latch was not moved to the • Move the latch to the right as far as it will _q> See the
right when the OVEN TEMP knob Using the self-cleaning oven section.
was set to CLEAN.
Self clean light (on A power interruption occurred. •Turn the OVEN TEMP knob to OFFand move the latch
some models) blinks to the left as far as it will go. Reset
the range controls
during self clean cycle
to the desired settings.
See the Using the self-cleaning
oven section.
"Boor"appears in the Self-clemahzg cycle has been • Move the latch lmndle :ill the way to the right.
display ton some modelsl selected but the latch handle
was not moved all the way
to the fight.
Latch hm_dle was moved to the
right but a progrmn other thml
self-clemth_g was selected.
• Move the latch handle to the right onl} when ,setfino
the sell:cleaning cycle.
"T--and a number or On models with a door latch, • The latch may have been re(wed, even if only slightly,
letter"flash in the display if a function error code appears fi'om the locked position. Make sure the latch is m(>ved
(on some models/ during the self-clemahlg cycle, to the right as thr as it will go.
check the oven door latch.
You have a ftmcfion error code.
• Touch the CLEAR/OFFpad. _dlow the oven to cool for
one holm Put the oven back into operation.
If the function code repeats. • Discom_ect :Ill power to the range tor 5 minutes
:rod then recom_ect l)owe_:/f the flmction error
code repeats, call ti)r service.
46