Table of Contents
Advertisement
Thank
you
for purchasing
the Onkyo
TX-SV343
Audio Video Control Receiver.
Please read this manual thoroughly before making
connections and operating the unit.
Following
the
instructions
in this
manual
will
enable
you to obtain
optimum
performance
and
listening enjoyment from your new A/V Receiver.
Please retain this manual for future reference.
Features
Power output:
USA & Canadian modeis:
Stereo mode
60 watts
per channel,
min.
RMS
into 8 ohms,
both channels driven from 20 Hz to 20 kHz with
no more than 0.08% THD.
Surround mode
Front L/R Channels
2 « 50 W (1 kHz, 0.08%, 8 ohms)
Center Channel
50 W (1 kHz, 0.15%. 8 ohms)
Rear Channels (Rear channel only driven)
ISW+!5W
(1 kHz, 0.3%, 8 ohms}
European models:
Stereo mode
2 Xx 60 watts at 6 ohms (DIN)
Surround mode
Front L/R and Center Channels
3 x 50 watts at 6 ohms (DIN)
Rear Channels (Rear channel only driven)
15 watts + |S watts at 6 ohms (DIN)
Asian models:
Note to CATV system installer:
e
This reminder is provided to call the CATV system installer's
attention to Section 820-40 of the NEC which provides guide-
lines for proper grounding and, in particular, specifies that the
cable ground shall be connected to the grounding system of the
building, as close to the point of cable entry as practical.
e@ For models having a power cord with a polarized plug.
CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH
WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.
e
Sur les modeéles dont la fiche est polarisée.
ATTENTION:
POUR
EVITER
LES
CHOCS
ELEC-
TRIQUES. INTRODUIRE LA LAME LA PLUS LARGE DE LA
FICHE DANS LA BORNE CORRESPONDANTE DE LA PRISE
ET POUSSER JUSQU' AU FOND.
Declaration of Conformity
We, ONKYO EUROPE
ELECTRONICS GMBH
INDUSTRIESTRASSE
18/20
82110 GERMERING,
GERMANY
declare in own responsibility. that the ONK YO product described
in this instruction manual 1s in compliance with the corresponding
technical standards such as ENSS5013,EN55020,.EN60555-2.
EN60065
Stereo mode
an
2 x 80 watts at 6 ohms, 1 kHz (EIAD
GERMERING,GERMANY
ALE
Front L/R and Center Channels
3 x 65 watts at 6 ohms, | kHz (EIAJ)
ONKYO
EUROPE ELECTRONICS
GMBH
Rear Channels (Rear channel only driven)
20 watts + 20 watts at 6 ohms, | kHz (EIAJ)
e
Dolby Pro Logic and Hall Surround
mode for spacious
sound
Replacement and mounting of an AC plug on the power supply cord
e All channels boast discrete output stage circuits (extremely
of this unit should be performed only by qualified service personnel,
rare in this receiver class) for accurate high-current, low-
IMPORTANT:
impedance drive
e
Costly, high-quality parts such as large power transistors,
oversized transformer and a heavy-duty, one-piece, extruded
The
wires in the mains
lead are coloured
in accordance
with the
following code:
Battery-free memory backup
fRI Compatible remote control
for the ASTA mark or the BSI mark on the body of the fuse.
IF THE
FITTED
MOULDED
PLUG
IS UNSUITABLE
FOR
THE SOCKET OUTLET IN YOUR HOME THEN THE FUSE
Manufactured under license from Dolby Laboratories Licens-
SHOULD
BE REMOVED
AND
THE
PLUG
CUT
OFF
AND
ing Corporation.
DISPOSED OF SAFELY. THERE !S A DANGER OF SEVERE
DOLBY, the double-D symbol DO and "PRO LOGIC" are
ELECTRICAL SHOCK IF THE CUT OFF PLUG IS INSERTED
trademarks of Dolby Laboratories Licensing Corporation.
INTO ANY 13 AMP SOCKET.
If in any doubt please consult a qualified electrician.
heat sink enhance low-impedance drive capability
Blue:
Ne utral
e
Dedicated line-level subwoofer output
Brown:
Live a
e
4 Audio and 2 AV inputs accommodate a complete AV system
As the colours of the wires in the mains lead of this appliance may
e
A/B Speaker selector and outputs
not correspond with the coloured markings identifying the termt-
e
Tape monitor
nals in your plug, proceed as follows:
e
Adjustable digital delay
The wire which is coloured BLUE must be connected to the terminal
e
30 FM/AM random presets
in the plug which ts marked with the letter N or coloured BLACK.
e Preset scan tuning
The wire which is coloured BROWN must be connected to the termi-
e 3 Station group presets (10 stations per group)
nal in the plug which is marked with the letter L or coloured RED.
e
RDS with PS (European models only)
e
Direct access tuning
IMPORTANT
e
Motor-driven, precision 4-gang volume control
A 5 amp fuse is fitted in this plug. Shoud the fuse need to be
e Headphone jack
replaced please ensure that the replacement fuse has a rating of 5
e Audio mute, sleep timer (via remote)
amps and that it is approved by ASTA or BSI to BS 1362. Check
e
e
Advertisement
Table of Contents
