Zanussi FC800 Instruction Booklet page 9

Set the hose correctly by loosening the rin<
nut. After positioning the inlet hose, be sun
to tighten the ring nut again to prevent
leaks. Fig. 9.
E neoeersrr
Fig 9
If you intend the drain hose from the
machine to empty into a sink, make sure
the sink is empty and that the plug hole is
not blocked.
lf the machine is permanently plumbed in,
hook the end of the hose into a standpipe
installed for the purpose.
The standpipe must have an internal
diameter of at least 40 mm (1 1/2"), in order
that there is an air gap between the drain
hose and the standpipe. Make sure, that it
is designed in such a way, that the end of
the drain hose cannot be covered with
water. See Fig. 10.
Important:
Before connecting up the machine to
new pipework or to pipework that has
not been used for some time, run off a
reasonable amount of water to flush out
any debris that may have collected in
the pipes.
Level the washing machine by loosening or
tightening the feet. Accurate levelling will
prevent vibration, oise and displacement
of the machine dt "ing operation.
See Fig. 11.
Fig 11
Some vibration is inevitable, especially if
mounted on a wooden floor.
Sprung wooden floors are particularly
susceptible to vibration. For advice, consult
a builder. If possible, always place the
machine on a solid floor.
Special Conditions
if the floor is carpeted with a deep-pile
carpet or covered with crumbly or soft
material, insert a rigid support base under
the feet to prevent noise, vibration or
displacement, this also allows air to
circulate around the appliance. The base
should protrude a few centimetres beyond
edges of the machine.
Note:
Please ensure that when the appliance is
installed it is easily accessible for the
engineer in the event of a breakdown.
All plumbing and electrical work required to
install this appliance must be carried out by
competent persons or qualified plumbers or
electricians.