Programming The Remote Control; Preprogramming Method - Home Theater Master MX-1000 Operating Manual

6. Programming the Remote Control

You can program the MX-1000 to make it compatible with all of your
components by following either the preprogramming method or
teaching it with your original remote controls.
A. Preprogramming Method:
1) Using a three-digit code number.
1. Turn on the component you plan to operate manually.
2. Go to the program setting mode by pressing both the MAIN and
PAGE buttons simultaneously for five seconds
3. Using the joystick, move the cursor down in the LCD screen to
3. PREPROGRAM.
4. Push the joystick down to enter the preprogramming mode.
5. Select the device on the LCD screen that you wish to program.
(E.g. To program TV, press the TV device button. )
6. Select the device from which the three digit code number table will
be selected from. (E.g. If it is from the TV code table, press the TV
device button.)
7. Point the remote control toward the component and enter the three-
digit code number you selected for your component from the code
table on page 40 Ð 53. ( Please enter the code number within 20
seconds of programming.) If there is more than one code number
assigned to your brand, try the one code number at a time until you
find the right code number. ( If you entered the right code number,
the component will turn off right after you entered the number.)
When the right code number is entered, save the code by pressing
the SAVE button on LCD.
9
6. Programming the Remote Control
8. Confirm that you entered the right code number that matches your
component by pressing other buttons such as POWER, VOLUME,
MUTE and CHANNEL. If any of the buttons do not operate as they
should, please repeat from Step 5.
9. Continue to program other components by repeating from the
above step 5.
10. Once you completed programming all the devices, exit from the
programming mode by pressing both the MAIN and PAGE
buttons simultaneously.
11. You will be in the setting mode once again. Move the cursor to
8. TO EXIT and press the cursor down or simply press the MAIN
button to exit to main menu.
2) Auto Scan with brand names.
You can also program your remote control by brand name with the
following steps:
1. Manually turn on the component you plan to operate.
2. Go to program setting mode in the remote control by pressing both
the MAIN and PAGE buttons simultaneously for five seconds.
3. Using the joystick, move the cursor down in the LCD screen to
3. PREPROGRAM.
4. Push the joystick down to enter the preprogram mode.
5. Select the device you wish to program in the LCD screen.
(E.g. To program TV, press the TV device button. )
6. Select the device from which the three digit code number will be
selected from. (E.g. If it is from the TV code table, press the TV device
button.)
10