To Erase The Learned Buttons - Home Theater Master MX-1000 Operating Manual

6. Programming the Remote Control
4. Place your original remote control to the MX-1000 head to head
about 2-3 inches apart as shown below.
5. Press either the device button or functional button, whichever you
wish to teach in the MX-1000. It is now ready to learn on the button
you selected.
6. Press the button on your original remote control that you wish to
teach into the MX-1000. The MX-1000 will "beep" indicating that
it received the signal and the LCD will show "RETRY".
( Please enter the code signal within 20 seconds of programming.)
7. Press the same button on the original remote control a second time
to ensure correct learning. The MX-1000 will beep a second time
with "GOOD" flashed on the LCD screen, indicating that it learned
the code correctly. If it flashes "FAIL", repeat from Step 5 until it
learns successfully.
8. Move on to the next button (or device) you wish to teach by
repeating from Step 5. If you are teaching functional buttons, you
can also move on to teach the buttons in the next page by pressing
the PAGE button.
9. Once you complete the teaching and wish to exit from the leaning
mode, press the MAIN button to go back to the main page of the
learning mode. Exit from the Main page by pressing both the MAIN
and PAGE buttons simultaneously.
10. You will be in the setting mode once again. Move the cursor to
8. TO EXIT and press down the cursor or simply press the MAIN
button to exit to the main menu.
13
6. Programming the Remote Control
C. To Erase the Learned Buttons
1) To erase a single button:
1. Go to the program setting mode by pressing both the MAIN and
PAGE buttons simultaneously for five seconds.
2. Move the cursor to 4. Learning with the joystick and then push the
joystick down to enter the learning mode.
3. Move the cursor to COMMON BUTTON and select the device
that contains the functional button you wish to erase. If you wish to
erase the function in the device button, move the cursor to DEVICE
BUTTON.
4. Press the functional button or device button you wish to erase for
three seconds or more and it will flash "ERASED". Repeat this step
for other buttons you wish to erase.
5. Once you completed erasing and wish to exit from this mode,
press the MAIN button to go back to the main page of the learning
mode. Exit from the Main page by pressing both the MAIN and
PAGE buttons simultaneously.
6. You will be in the setting mode once again. Move the cursor to
8. TO EXIT and press down the cursor or simply press the MAIN
button to exit to the main menu.
2) To erase all the learned commands in a single device:
1. Go to the program setting mode by pressing both the MAIN and
PAGE buttons simultaneously for five seconds.
2. Move the cursor to 4. Learning with the joystick and then push the
joystick down to enter the learning mode.
14