Features And Benefits; Parts Guide - Universal Remote MRF-350 Installation Manual

Features and Benefits

Interference Rejection and Extended RF Range via RFX-250
The MRF-350 receives RF (radio frequency) signals via the RFX-250 RF Sensor.
The RFX-250 displays RF interference via a bright red LED, which flickers when
interference is present. Simply relocate the RFX-250 out of the interference.
Expand Range by Adding RFX-250 RF Sensors in Remote Areas
The MRF-350 can power up to three RFX-250 RF Sensors connected in parallel
to the RF Input connector.
Variable IR Output Matches Rear Panel IR Inputs
The MRF-350 is equipped with adjustable IR line outputs, each output can be indi-
vidually matched to rear panel IR inputs on any component that is designed to be
operated by a standard IR repeater.The outputs utilize a 3.5mm jack.
Up To Fifteen Equipment Locations With Identical Components
Each MSC System remote is "addressable." They can be programmed to specifi-
cally control components in a particular room by installing a base station at each
location. In operation it's simple: when you select a device located in the Den,
the MX series remote only sends commands to the Den. When you select a
device located in the Family Room, the MX-3000 only sends commands to it.
A Single MRF-350 Can Control an Array of Identical Components
or Identical Zones of a Multi Zone Preamp/Matrix Switcher
Each MRF-350 has six "addressable" IR Line Outputs. For example, you can con-
trol up to six identical TV's with one MRF-350 or route volume commands for a
specific zone to a particular zone IR input on a multi-zone preamp. If you have
more than six identical components or zones, up to 15 additional MRF-350s can
be installed to control them (thus allowing up to 90 identical components or
zones in one house).
IR Input for Keypads or IR Repeater Systems
The MRF-350 rear panel IR input will relay IR Data from IR repeaters or Multi-
Zone Keypads to all IR line outputs (does not support IR routing).The 5V, 100
milliamp output will directly power some brands and models of keypad directly.

Parts Guide

The MRF-350 RF Base Station includes:
1 - RFX-250 RF Sensor with integrated
antenna
1 - Mounting plate for RFX-250
1 - MRF-350 Base Station
1 - Mounting Plate for wall mounting the
MRF-350
8 - Screws for wall mounting the two
mounting plates
1 - 9V-300mA Power Supply
MRF-350 B S
ASE TATION
6 - Visible Flashers with 10 foot plug in cables.
6 - Extra self adhesive pads for Emitters
1 - 12' Connecting Cable
1 - Adjustment Tool (Screwdriver for RF ID
and IR level adjustment)
2 - Depluggable screw connectors for RF
connections when extending wires.
Page 2