Recalling Pre-Programmed Settings - Universal Remote Automator URC-200 Owner's Manual

Recalling Pre-Programmed Settings

If you didn't write down the code numbers you setup
your Automator with, you can recall them via this
simple process:
Enter SETUP mode by pressing and holding both
1
MAIN and ENT for three seconds.
Note: You have 30 seconds for each step, otherwise the
Automator will time out automatically.
Go to page two of the SETUP menu via the PAGE
2
UP button.
Press the RECAL button. The display changes to the
3
recall screens. The screen automatically switches
between four screens, alternately flashing page one
devices and code numbers then those for page two.
Note: Pay attention to the page numbers on the bottom
of the screen. Page 1 code numbers are the ones setup
for the Page1 Devices. Page 2 code numbers are the
ones setup for the Page 2 Devices.
Write down the code numbers as they appear. Page
4
32 of this manual gives a convenient list for you to
note your settings.
Return to normal operation by pressing the MAIN
5
button twice.
U R C - 2 0 0
29