Cloning One Automator To Another - Universal Remote Automator URC-200 Owner's Manual

Cloning One Automator to Another

If you own two or more Automators, you can copy and
transfer all the setup from one Automator to another.
Just follow these easy steps:
Enter SETUP mode by pressing and holding both
1
MAIN and ENT for three seconds.
Note: You have 30 seconds for each step, otherwise the
Automator will time out automatically.
2
Press a PAGE button to display page two of Setup.
3
Press the CLONE button.
Align the two Automators head-to-head, about an
4
inch apart.
Press the RECV display button on the new
5
Automator you would like to setup by cloning.
Press the SEND display button on the Automator
6
you previously setup.
Press the START button on the new Automator
7
and then press the START button on the
Automator you previously setup.
Note: Cloning typically takes about 40 seconds.
After completion, the cloned Automator will flash
"GOOD".
Return to normal operation by pressing the MAIN
8
button twice.
T h e A u t o m a t o r
28