Wave Pacific Installation And User Manual page 15

5.3. Drainage and storage
Drainage
Check the stopper on the bottom of the pool and the drain cap.
1
Unscrew the drain cap.
2
Remove the stopper on the bottom of the pool. Completely drain all water from the spa pool.
3
Once empty, the pool can be cleaned with soap and water.
4
1
Storage
Press the bubbling button to blow out the water inside the jet holes. Unplug the pump, remove the
5
filter cartidge from the inner wall of the pool
Use a towel to wipe off the pool, dry for 24 hours.
6
Unscrew the valves to deflate the pool.
7
Fold the pool.
8
It is recommended that store the SPA in its original package in a warm dry place.
5
5.4 Repair kit
Little holes or punctures can be repaired with the repair kit included and glue reserved to pool liner
1. Find the leak.
2. Thoroughly clean the area surrounding the leak
3. Cut a piece of repair material in round shape, which should be larger than the damaged area.
4. Apply adhesive to the underneath side of the patch and around the area to be repairs.
5. Put the patch on the damaged area and press down firmly. Allow 12 hours for repair to dry. After patch
has dried, apply glue around the edges for a complete seal (dry for 4 hours).
2
6
3
7 8
EN
15