JL Audio Gotham v2 Owner's Manual page 25

SYSTEM CONNECTION DIAGRAM 4:
Two Gotham v2s in Stereo to
Two-Channel Audio System
When connecting two Gotham v2s in
stereo to a two-channel audio system you
will only use the "Left or Mono" inputs of
each Gotham v2. The upper "Input Mode"
switch on each Gotham v2 will be set in
the "Master" position.
We strongly recommend that you use
a high-quality active crossover, like the JL
Audio CR-1, to divide your preamplifier's
signals prior to connection to the Gotham
v2 and to the amplifier driving your main
speakers. This will allow you to filter low
frequencies out of the signals driving
the main speakers, resulting in better
performance.
If you are not using an active crossover
and are comfortable running your main
speakers full-range, you can split your
preamplifier's output signals using
appropriate Y-connectors in place of the
active crossover shown in the diagram.
Two connection types are available
for connecting the Gotham v2s to your
two-channel audio system: balanced
(XLR or 1/4-inch TRS connector) and
unbalanced (RCA-type connector).
Balanced connections provide superior
noise rejection and ensure proper
grounding between components. If your
preamplifier or active crossover offers
balanced outputs, we highly recommend
that you use them.
In the connection diagram at right,
balanced connections are shown as solid
lines, unbalanced connections are shown
dotted. You will only use one of these
input connection methods (not both).
NOTE: If desired, additional Gotham v2s
can be connected in "Slave" mode to each
Gotham v2 connected as shown on this
diagram. See "Connection Diagram 2" on
page 23 for slave connection explanation.
WARNING
| Gotham
v2
®
STEREO ACTIVE CROSSOVER (BALANCED OUTPUTS)
LOW OUT
(SUB OUT)
GOTHAM REAR CONTROLS (MASTER)
GOTHAM REAR CONTROLS (SLAVE)
WARNING! TURN OFF THE GOTHAM v2(s) AND ALL OTHER EQUIPMENT IN
THE SYSTEM BEFORE MAKING OR CHANGING ANY CONNECTIONS!
STEREO ACTIVE CROSSOVER (UNBALANCED OUTPUTS)
LOW OUT
(SUB OUT)
LEFT
OR
RIGHT
Pg 25 | EN