JL Audio Gotham v2 Owner's Manual page 22

RECEIVER / PROCESSOR (UNBALANCED OUTPUTS)
PRE OUT
FRONT L REAR CENTER
FRONT R REAR
WARNING! TURN OFF THE GOTHAM v2 AND ALL OTHER EQUIPMENT IN
THE SYSTEM BEFORE MAKING OR CHANGING ANY CONNECTIONS!
EN | Pg 22
PROCESSOR (BALANCED OUTPUTS)
OR
SUB
GOTHAM REAR CONTROLS (MASTER)
OUTPUTS
SYSTEM CONNECTION DIAGRAM 1:
One Gotham v2 to
Home Theater Receiver or
Home Theater Preamp/Processor
Most home theater receivers and
preamp/processors provide a single
(mono) subwoofer output. When
connecting a mono subwoofer output to
your Gotham v2, you will only use the
Gotham's "Left or Mono" input.
Two connection types are available
for connecting the Gotham v2 to your
home theater system: balanced (XLR or
1/4-inch TRS connector) and unbalanced
(RCA-type connector). Balanced
connections provide superior noise
rejection and ensure proper grounding
between components. If your receiver or
processor has balanced outputs, we highly
recommend that you use them.
In the connection diagram at left,
balanced connections are shown as solid
lines, unbalanced connections are shown
dotted. You will only use one of these
input connection methods (not both).
WARNING
| Gotham
v2
®