Makita DTD155 Repair Manual page 17

Fig. 41
Fig. 42
[2]
[3]
Fig. 43
[2]
Fig. 44
[2]
[3]
[1]
5
.
Insert three Straight terminals firmly because loose
connection leads to abnormal rotation.
6
Be careful not to twist Lead wires.
[1]
7
[1]
8


[4]
Route LED Lead wire [4] under all other Lead wires.
17 / 26
Connect three Straight terminals between Controller and
Stator correctly. Connect wires of similar colors
Note
Flip the cover of Switch [3], then insert Connector into
Connector socket [1] and then connect two Flag terminals
[2] to Switch; connect Red terminal to B1 and White
terminal to B2.
Note
Connect Connector [1] of LED circuit [2] to Controller.
Install Hammer case [1] on Motor section and then
assemble them to Housing L [2].
Note
Check Hammer case [1] rotates without wobbling.
Engage the groove of Stator [3] and the projection of
Housing L [2]. Engage the hole of Hammer case [1] and
that of Housing L [2].
Tip